24.11.2012 Views

Gebrauchsanweisung CB 75 F + ... - tapo-fix

Gebrauchsanweisung CB 75 F + ... - tapo-fix

Gebrauchsanweisung CB 75 F + ... - tapo-fix

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

6. Prepare machine for use<br />

Open the lid of the pasting machine. Place paper face up on the paste applicator and<br />

press it lightly against the paste applicator. Lay the paper on the support rod, and<br />

close the lid of the machine.<br />

Note: Always put back of paper on paste applicator.<br />

Cutting groove<br />

Support rod<br />

Cutting tool<br />

Turn paste applicator<br />

8. Cutting the paper<br />

Apply light pressure to cutting tool when pulling it along the cutting groove. Paper may<br />

folded or handled as usual.<br />

10. Paste Well Divider<br />

<strong>CB</strong>-Counter<br />

7. Measuring wallpaper<br />

When using a <strong>CB</strong>-Counter ( accessory), pull the paper to the cutting groove and reset<br />

counter to zero, and then pull paper to required length.<br />

Otherwise mark length of wallpaper required on the pasting table with masking<br />

tape (measure from the cutting groove). Pull paper through the machine to mark. If<br />

the paper is longer than the table, measure back from the end of the table and<br />

mark, folding paper over to obtain length.<br />

Note: Fold corners of paper as shown above before pulling paper through<br />

machine.<br />

9. Cleaning the machine<br />

Cleaning is required only after heavy use or when the machine will not be used for<br />

some time. To clean, drain remaining paste. Set the dial indicator at the highest<br />

setting (largest opening), and remove the paste applicator by inserting your hand<br />

between the paste applicator and bottom of the past well, pressing roll up and out of<br />

bearings.<br />

Note: Before removing paste applicator dial indicator adjustment should be in the full,<br />

open position. Before storing for long periods machine should be<br />

cleaned, especially underside of wiper to remove accumulated residue.<br />

( accessory)<br />

Use the paste well divider(Item No. KKT) in the<br />

<strong>CB</strong> 1000 F pasting machine to save paste when using<br />

smaller width papers. Only fill the working area with<br />

paste when you use a paste well divider in your<br />

pasting machine.<br />

Cutting groove<br />

<strong>tapo</strong>-<strong>fix</strong> GmbH & Co. KG<br />

Meinstraße 114 • D-38448 Wolfsburg Telefon +49 5363 9771-0 Telefax +49 5363 9771-50<br />

e-mail: info@<strong>tapo</strong><strong>fix</strong>.de Internet: www.<strong>tapo</strong><strong>fix</strong>.de<br />

Printed in Germany 04/08

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!