ELECTRA-flo - V1.5x - 9-19-11.PMD - Air Monitor Corporation

ELECTRA-floSECTION 5 – OPERATION5.9 – DISPLAY CONFIGURATION (con't)1. While in Operator Menu, use UP or DN to scroll to: DisplayConfiguration2. Press ENT to enter Display Configuration menu. Display will indicate: Display FilterSelection3. Press ENT and display will indicate current setting of the filter [0 (None), 1 (Minimum), 2, 3, 4, or 5 (Maximum)].4. Use UP or DN to change setting. Once desired setting is displayed, press ENT, new setting will be stored inmemory and display will return to Display Configuration menu as in Step 2.Note: If user desires not to change the setting and return to the Display Configuration menu, press ESC. Unitwill remain programmed as it was originally.5. Use UP and display will indicate: Line 2 ParameterSelection6. Press ENT and display will indicate current parameter selected to display on Line 2 (VELOCITY,TEMPERATURE, or CUSTOM TEXT).7. Use UP or DN to scroll to desired parameter. Press ENT, and parameter will be stored in memory and displaywill indicate as in Step 5.Note: If user desires not to change the setting and return to the Setup menu, press ESC. Unit will remainprogrammed as it was originally.8. If CUSTOM TEXT was selected and ENT pressed in Step 7, proceed to Step 13. For other parameters,continue with Step 9.9. Press UP and display will indicate: Line 3 ParameterSelection10. Repeat Steps 6 through 8 for Line 3. The only differences being the change of Line # in the display.11. After Line 3 has been set, Step 9 will yield a display: Return toMAIN MENU12. Press ENT to return to Main Menu.Air Monitor Corporation116-053-13.P65 (2/28/12)18ELECTRA-flo - IO&M Manual