MS Series Installation, Operation & Maintenance Manual PDF ...

mr.steam ®Installation, Operation & Maintenance Manual__________________________________________________________________________CARE TIPS FOR ALL CONTROLS AND STEAMHEADS1. Use only mild soap and water on a soft cloth to clean the control and steamhead.2. Do not use abrasive cleansers.3. If the decorative cover is damaged on the iTempo or iTempo/Plus call Mr.Steamtechnical service for replacement parts.NOTE: Replacement of the decorative covers requires removaland reinstallation of the control from the mounting surfaces.STEAM GENERATOR MAINTENANCEMr.Steam steambath generators require little maintenance.Other than periodic draining, maintenance procedures areminimal. Every 2 months, or more often in “hard” waterareas, the manual drain valve should be opened fully flushingout accumulated materials, salts and other particles whichare natural by-products of boiling water.! CAUTION Flush a minimum of two-three hours after thecontrol has been turned off to insure that the water has cooled.! WARNING Draining immediately after a steam cycle mayexpose PVC and other piping to high temperature water. Checklocal codes. The unit will refill automatically when the control isactivated again. In areas of hard water, a Mr.Steam AutoFlush ®system is recommended for generator longevity.! WARNING Failure to allow the water to cool will exposethe equipment and user to scalding water and cause propertyand personal injury.STEAM GENERATOR OPERATIONSet the steambathing temperature according topersonal preference, however it is highly recommendedto begin steambathing at a low temperaturesetting to gauge comfort and safety levels.Set the duration at 10 minutes max. to gaugecomfort and safety levels. This will allow the steamgenerator to heat up and begin producingH O M E O W N E RWARRANTYTo view or download the Mr. Steam Residential Generator Warrantyand register your Product go to: blog.mrsteam.com/wr21