Saturn OneTouch Installation Sheet - Schneider Electric

More documents

Recommendations

Info

60TxM Series3.0 FeaturesSaturn OneTouch Installation Instructions• Integrally switched modular electronic switch and dimmer mechanisms• Touch sensitive control interface• Visual and audible indicators• Multi-Way “Remote” wiring capability allows 1-3 Way Control• Built using Clipsal C-Thru® Universal Dimming Technology• Incorporates advanced load handling facilities• 400W Power Rating (Switch) / 350W Power Rating (Dimmer)• Suitable for a wide range of load types: Incandescent lamps 240V halogen / dichroic lamps Low voltage downlights using electronic transformers Low voltage downlights using iron-core transformers• Compatible with selected Dimmable CFL and LED loads*• Automatic soft-start / kick-start operation depending on the load type• Automatic minimum brightness regulation depending on the load type• Multi-gang capacity up to six (6) touch mechanisms per plate• Easy wiring using onboard integral terminals• Wall or architrave mounting options• Wide range of plate styles and colour variants available• Suitable for new installations or retro-fit applications• Inbuilt over-current and over-temperature protection• Full short circuit protection• Immune to high frequency (ripple) signal injection on mains supply• Complies with Australian and International EMC Standards*Some loads require 31CAP Load Correction Device to be fitted in order to ensurecorrect operation.6 of 20 Clipsal by Schneider Electric
60TxM Series4.0 Unit OperationSaturn OneTouch Installation InstructionsTOUCH CONTROL OPERATIONACTIONSHORT TOUCHLONG TOUCHDESCRIPTIONSWITCH• Tap the touch sensitive area to turn the load On or Off.DIMMER• Tap the touch sensitive area to turn the load On or Off.• The dimmer has memory, and will remember theprevious dim setting. When you tap the touch sensitivearea to turn the light Off, the unit will store the currentsetting in memory. When you tap the touch sensitivearea to turn the light On, the dimmer will restore theprevious dim setting.SWITCH• Press and hold the touch sensitive area to turn the loadOn or Off.DIMMER• Press and hold the touch sensitive area to dim up anddown. Release to stop dimming.• The dimmer will cycle up and down alternately. Whenthe light is On, the dimmer will dim down (decreasebrightness) by default. When the dimmer is Off, itwill dim upwards (increase brightness) by default.Subsequent Long Touch will dim in the oppositedirection.• Whilst dimming, if the dimmer reaches its maximumor minimum brightness level, the unit will pause for1.5 seconds, and the LED will flash rapidly to indicateas such. After 1.5 seconds the dimmer will then startdimming in the opposite direction.• A single ramp cycle takes about 10 seconds to complete(full range, min to max).• If the touch sensitive area is not pressed for 15seconds, the dimming is set to dim down / fade out bydefault again.Note that Remote unit operation will be “locked-out” one second after each “on”operation while the load responds to commands. During this time the unit willsound the alert tone if pressed, but the load will not respond further.Clipsal by Schneider Electric7 of 20
Page 3 and 4: 60TxM Series1.0 Product RangeSaturn
Page 5: 60TxM Series2.0 DescriptionSaturn O
Page 9 and 10: 60TxM SeriesSaturn OneTouch Install
Page 11: 60TxM Series7.0 Setup ModeSaturn On
Page 15 and 16: 60TxM Series11.0 Wiring DiagramsSat
Page 17 and 18: 60TxM SeriesSaturn OneTouch Install
Page 19 and 20: 60TxM Series12.0 Electrical Specifi

Saturn OneTouch Installation Sheet - Schneider Electric

Create successful ePaper yourself

Delete template?

Save as template?