CMD-III/16:1786 - BIS

nominal size by 40 per cent and 80 per cent respectively. The bond test in such cases shall be done in accordance with IS:2770(Part I). Pull out test shall be done in addition to 5.2 for approval of new or amended geometry for first licence.5.9.2 The quantity of high strength deformed steel bars and wires in a lot shall be considered as fit to be covered under BIScertification marks scheme if they conform to the dimensions ,deformations mass and surface characteristics as specified and are freefrom cracks ,harmfull surface flows , laminations ,rough and imperfect edges,and all other defects and also satisfy the physical andchemical requirement of the specification5.10 The licensee shall also verify the deformation pattern of the high strengthdeformed steel bars and wires on the production line preferably at an interval of one hour at each twisting machine against theregistered design. Proper records shall be maintained for this.6. REJECTIONS – A separate record shall be maintained giving information relating to the rejection of the production notconforming to the requirements of the specification and the method of its disposal. Such material shall in no circumstances bestored together with that conforming to the specification.7 SAMPLES – The licensee shall supply, free of charge, the samples required in accordance with the Bureau of IndianStandards (Certification) Regulations, 1988, as subsequently amended, from the factory or godowns. The Bureau shall pay forthe samples taken by it from the open market.STI/1786/R-1/9Sept. 20088 REPLACEMENT – Whenever a complaint is received soon after the goods with Standard Marks have been purchased andused, and if there is adequate evidence that the goods have not been misused, defective goods or their components are replacedor repaired free of cost by the licensee in case the complaint is proved to be genuine and the warranty period (whereapplicable) has not expired. The final authority to judge the conformity of the product to the Indian Standard shall be with theBureau. The firm shall have own complaint investigation system as per IS/ISO 10002.8.1 In the event of any damages caused by the goods bearing the Standard Mark, or claim being filed by the consumers againstBIS Standard Mark and not “conforming to” the relevant Indian Standard, entire liability arising out of such non conformingproduct shall be of licensee and BIS shall not in any way be responsible in such cases.