Warning - koukaam

More documents

Recommendations

Info

5.2.1 Configuration of network parametersClick Configuration link in the menu to change the system configuration.Here, you can set up IP Address, Subnet Mask, Default Gateway and DNS Server according to yournetwork parameters. If you do not wish to setup the network parameters manually, you can EnableDHCP to obtain requested parameters automatically from the DHCP server in your network.The parameter Switch delay (x0.1s) specifies delay between triggering two outputs. It avoids overloadingof the device supply by turning all outputs ON at the same time.The selections KSHELL Port and WEB Port allow change of default output for access via telnet,eventually, device web interface.Device name allows you to insert the name of your device for easier identification in the future.Firmware version is just informative and shows the current firmware version.After you make requested changes on this page and click Apply the device will change the parametersand restart automatically. After the restart you will have to login again. Reset To Default buttonrestores factory default settings.Figure 9:5.2.2 E-mail configurationClick Setup e-mail and the form for adjusting e-mail settings can be seen on the right. Please inputsender (From), and recipient (To) of e-mail message. Also input the SMTP server address that will beused to send out the e-mail. The last field (<strong>Warning</strong> MSG) is used to input the subject of the e-mailmessage sent.Click Apply to save. You can check if e-mail setup is correct by pressing the Send test messagebutton.11
Note: Current firmware version does not support SMTP authorization.Figure 10: Setup e-mail5.2.3 Date and time settingsClick Date & time in the menu and the system date and time settings will appear on the right.NETIO-230B supports two methods of getting the right date and time values. It can be enteredmanually or obtained automatically from the SNTP server.Figure 11: Setup time and date• SNTP enable: Enables time synchronization with SNTP server.• SNTP status: SNTP server synchronization status:12
Page 2: WarningUnauthorized modification of
Page 5 and 6: • Latency: 300x60x90 mm (WxHxL)
Page 7 and 8: Figure 3: device set-up3. Choose th
Page 9 and 10: Figure 6: manual controlnot, the de
Page 11: event will be triggered once per we
Page 15 and 16: • Guest: User who is not authoriz
Page 17 and 18: 3. The device should give you the r
Page 19 and 20: • - IP address of monitored devi
Page 21 and 22: • 553 INVALID LOGIN - Incorrect u

Warning - koukaam

Create successful ePaper yourself

Delete template?

Save as template?