maintenance - Polaris

OPERATIONAll Wheel Drive (AWD)Engaging AWDPress the top of the switch to engage All Wheel Drive(AWD). The 4X4 indicator illuminates in the riderinformation center to indicate that the vehicle is inAWD. See page 25.When the AWD switch is on, the front wheels willautomatically engage any time the rear wheels losetraction. When the rear wheels regain traction, thefront wheels will automatically disengage. There isno limit to the length of time the vehicle may remainin AWD.AWDDifferential LockDifferential UnlockTip: The AWD switch may be turned on or off while the vehicle is moving.Engage the AWD before getting into conditions where front wheel drive may be needed. Ifthe rear wheels are spinning, release the throttle before switching to AWD.NOTICE: Switching to AWD while the rear wheels are spinning may cause severe drive shaft andclutch damage. Always switch to AWD while the rear wheels have traction or are at rest.Disengaging AWDMove the AWD switch to the center or bottom position to disengage AWD. If the switch isturned off while the front hubs are driving, they will not release until the rear wheels regaintraction.In some situations, the front gearcase may remain locked after turning the AWD switch off.If this occurs, you may notice increased steering effort and some vehicle speed restriction.Perform the following procedure to unlock the front gearcase.1. Stop the vehicle.2. Operate in reverse for at least 10 feet (3 m).3. Stop completely.4. Shift into low gear and drive forward.5. If the front gearcase remains locked after following these instructions, see your dealerfor service.40