Installation Guideline MPC Micro-Topping System Interior ... - Miracote

Installation GuidelineMPC Micro-Topping SystemInterior /Exterior with Reactive StainNominal 3/32 InchStep # Installation Step Installation Methods Products & Mix Ratios Theoretical Coverage RatesPrepare a mixture of 1/2 cup baking soda to 5 gallons potable water. Spread solution onto floor and scrub with broom or auto7 Neutralize Stained Concrete Surface scrubber/floor machine with white buffing pad. Vacuum residue, and rinse floor with clean water. Repeat this process until PHtests verify a neutral condition before applying any top coat or sealer.Option 1 - Application of MPC Micro-Topping Clear Sealers - For both Exterior & Interior UseOptional - Apply 1 or 2 Coats of Clear Sealer a. Hudson-type sprayer or HD II Clear, Gloss or Matte 400 SF/Gal(For Exterior & Interior Use) b. Roller, Applicator Pad or Note: HD II may be thinned with Acetone by 25% max.8aor8b Note 1: Two coats are always recommended Mirathane U/A, Gloss or Matte 400 SF/Galfor high traffic areas and/or stain resistence. Warning: Clear acrylic sealers orNote 2: When matte finish is desired, it is must be applied in a thin film. Miraseal 600 SF/Galrecommended to apply 1st coat with gloss. Maintain stated coverage rates.Option 2 - Application of MPC Micro-Topping Clear Top Coat (Required) and Clear Finish Coats (Optional) - For Interior Use Only9Apply Clear Top Coat a. Squeegee and Backroll CQ Matrix Clear(For Interior Applications Only) Mix Ratio A:B = 2:1 by Volume 250 SF/GalNote: It is important to maintain a wet edgewhen installing clear sealer coats & finishes.Optional - Apply 1 or 2 Clear Finish Coats a. Squeegee and Backroll Mirathane APU Clear Gloss or Matte 325 SF/Galfor Interior Use Only Mix Ratio A:B = 1:1 5 mils WFT10aor10b Note 1: Two coats are always recommended Glazetop XT Clear Gloss 325 SF/Galfor high traffic areas and/or stain resistence. Mix Ratio A:B = 1:1 5 mils WFTNote 2: When matte finish is desired, it isrecommended to apply 1st coat with gloss.Note:Prior to starting the application of any Miracote Product or System be sure to read the Installation Guideline Manual. Appendices, Product Data Sheets, MSDS and other pertinent documentspublished by Crossfield Product Corp. for information, including but not limited to, Precautions, Limitations, Disclaimers and Warranties.Pay special attention to substrate moisture content, physical condition of the substrate, method(s) of surface preparation, surface restoration, detailing of cracks, joints, transitions and terminations,and any applicable specifications. Review carefully for unknown site conditions or defects.The theoretical coverage rates stated in the Installation Guides are for estimating purposes only. Factors, such as, allowance for material waste, unusual or abnormal substrate conditions and otherunforeseen job site conditions that may affect actual product yields are the responsibility of the installer.Miracote is a registered trade name of Crossfield Products Corp.MPC is a registered trade mark of Crossfield Products Corp. Page 2 of 2 IEH Pending