Trim Cylinders
Trim Cylinders
Trim Cylinders
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3. Remove front and rear power trim cylinder mounting hardware.a b c de e f gh71489a - Anchor Pin (1)b - Slots (2)c - Flat Washer (Large I.D.) (2)d - Snap Rings (2)e - Rubber Bushings (4)f - Flat Washer (Small I.D.) (2)g - Locknut (2)h - Plastic Cap (2)cadebcf22029Disassemblya - Rear Anchor Pinb - Large I.D. Washers (Port and Starboard)c - Rubber Bushings (2) (Port and Starboard)d - Small I.D. Washers (Port and Starboard)e - Locknuts (Port and Starboard)f - Plastic Caps (Port and Starboard)CAUTIONEnsure work area is clean before disassembling power trim cylinders. Cylinderparts can be damaged by dirt entering into power trim system.NOTE: Spanner Wrench Tool Part No. 91-821709.71233