Summit® WM3600 Wireless LAN Controller ... - Extreme Networks

.Chapter 4: Hardware SetupTerminal Settings19200bps transfer rate8 data bitsno parity1 stop bitno flow controlno hardware compressionSupplying Power to the Summit WM3600 wirelessLAN controllerRack mountbracketAC inletsym_01 Plug an approved AC power cord into the power connector at the back of the Summit WM3600wireless LAN controller.2 Plug the cord into a standard AC outlet with a voltage range of 100 to 240 VAC.WARNING!An improper shutdown can render the Summit WM3600 wireless LAN controller inoperable such that itcould require service by Extreme Networks Support. Do not remove AC power without first following the shutdownprocedure. An abrupt loss of power can corrupt the information stored on the device.Verifying the InstallationView the LEDs on the front panel of the Summit WM3600 wireless LAN controller to ensure the deviceis functioning properly. The normal LED pattern follows this path:●During the Power On Self Test (POST), the System 1 and System 2 LEDs both blink green.● If the POST test fails, the System 1 LED will blink amber. If the POST test succeeds, the System 1LED will be lit solid green.● As the software is initialized, the System 2 LED will blink green.22Summit ® WM3600 Wireless LAN Controller Installation Guide