SOLARMOUNT-E Installation Guide / Manual - Unirac

SOLARMOUNT-E COMPONENTSABBeamSOLARMOUNT-E Beam = 2.2” HeightFlange Attachment(1) 5/16” x 3-1/2” Zinc Plated Lag Bolt(1) Stainless steel washer(1) Flange Attachment - See Figure A(1) Clip - See Figure BBeam Splice / Lateral Retainer(4) Self-drilling screws (1-1/4”-20 hex washerhead stainless steel: 70 ksi minimumtensile strength)(1) Beam SpliceOPTIONAL COMPONENTS2-Piece Aluminum Standoff(1) 3/8” x 3/4” Hex Head Bolt(1) 3/8” x 1-3/4” EPDM Washer(1) Aluminum Standoff Base(1) Aluminum Cylinder - 3”, 4”, 6” or 7”See installation note on Pages 6 and 16.PositiveBeamStopEnd Clamp(1) 5/16” - 18 Stainless steel serrated headhex bolt (minimum tensile strength -70 ksi) Install to a torque of 10 ft-lbs(1) End ClampMid Clamp(1) 5/16” - 18 Stainless steel serrated headhex bolt (minimum tensile strength -70 ksi) Install to a torque of 10 ft-lbs(1) Mid ClampClamp Bolt Length (Inches) Module Height (Inches)1.25 0.95 to 1.601.75 1.45 to 2.00PositiveModuleStop Positive Beam Stop(2) Self-drilling screws (1-1/4”-20 hexwasher head stainless steel: 70 ksiminimum tensile strength)(1) Positive Beam StopSEE PAGE 11 FOR DETAILSHead Cap ScrewPositive Module Stop(1) Stainless Steel 1/4”-20 X 1/2” Socket(1) Serrated Flange NutSEE PAGE 11 FOR DETAILSPV Quick Mount(1) 5/16” x 3-1/2” Stainless SteelLag Bolt(1) 5/16” Sealing Washer(1) 5/16” EPDM Washer(1) 9½” x 12½” FlashingCreoTecc Tile Hook (Top)(1) 3/8-16 x 3/4” Hex Head Bolt(1) 3/8” Hex Head Nut(1) Aluminum Tile HookLeveling Components(1) Adjustable set of AluminumLeveling ComponentsUnirac Flat Flashing(1) 12” x 8” flashing withattached gasket(1) Aluminum squarecompression plate(1) 5/16” EPDM WasherACECLAMP JR - StandingSeam Metal RoofMounting SolutionPAGE3