SOLARMOUNT-E Installation Guide / Manual - Unirac

More documents

Recommendations

Info

3. Snap the Clip to the Flange AttachmentA B CThe clip is used to securethe attachmentInsert the clip onto eitherside of the attachmentEnsure clip is fully insertedinto the attachment1 24. Install Beam Retainer/Splices usingself-drilling screwsABPAGE8Retainer/splice may be installed on thetop or bottom flange of the beam. Atleast 1 retainer must be placed over anattachment for each run of beamsA drill driver may be used to installthe four (4) self-drilling screws. Overtighteningthe screws will result instripped threads.
5. Secure Flange Attachments to applicableroof attachmentsNOTE: DO NOT attach rail directly to roof without flashing, standoff, ACECLAMP JR.,or tile hook. See Roof Attachment Options on Page 6.NOTE: DO NOT fully tighten bolts until leveling is completed. See Page 10.NOTE: When installing on pitched roof configurations, locate double-wall section ofthe flange attachment on the downhill side of roof slope.NOTE: DO NOT re-use flange attachments.PeakDoublewallsideof flangeattachmentRoofFIGURE 8EavePAGE9
Page 1 and 2: SOLARMOUNT-E SOLARMOUNT-E: THE BEST
Page 3 and 4: SOLARMOUNT-E COMPONENTSABBeamSOLARM
Page 5 and 6: PLANNING YOUR SOLARMOUNT-EINSTALLNO
Page 7: 2. Snap Beam to Flange AttachmentNO
Page 14 and 15: Clamp Installation DetailFIGURE 11A
Page 16 and 17: TILT INSTALLATION OPTIONNOTE: Torqu
Page 18 and 19: 4. Mark and drill hole through Beam
Page 20: RSOLARMOUNT-E A HILTI GROUP COMPANY

SOLARMOUNT-E Installation Guide / Manual - Unirac

Create successful ePaper yourself

Delete template?

Save as template?