SOLARMOUNT-E Installation Guide / Manual - Unirac

More documents

Recommendations

Info

INSTALLATION INSTRUCTIONS1. Install Applicable Roof Attachment OptionRoof Attachment OptionsThere are many attachment methods available. Unirac recommends alwaysattaching to a structural roof member such as a rafter. Best practice requiresthat you use one of the attachment options below.RafterPossible Attachment PointFIGURE 6Two Piece Standoff CreoTecc Tile Hook PV Quick Mount Unirac Flat Flashing ACECLAMP JRNOTE: If attaching tilt legs to standoffs , Unirac recommends that the stock hole in theSOLARMOUNT-E Tilt Leg Foot be bored out for a 3/8” fastener to make it compatiblewith them. For applications where a 5/16” fastener will be used, the stock diameter holerequires no modification.PAGE6
2. Snap Beam to Flange AttachmentNOTE: Always engage the double-wall side of the flange attachment before snappingattachment onto beam. See below.NOTE: Do not use attachment if the engagement features on the attachment are bent,damaged, or obstructed by debris.FIGURE 7AInsert flange of beam intodouble-wall side of attachmentBRotate beam into attachmentCBeam is secured when anaudible “click” occursNOTE: DO NOT re-use flange attachments.PAGE7
Page 1 and 2: SOLARMOUNT-E SOLARMOUNT-E: THE BEST
Page 3 and 4: SOLARMOUNT-E COMPONENTSABBeamSOLARM
Page 5: PLANNING YOUR SOLARMOUNT-EINSTALLNO
Page 9 and 10: 5. Secure Flange Attachments to app
Page 14 and 15: Clamp Installation DetailFIGURE 11A
Page 16 and 17: TILT INSTALLATION OPTIONNOTE: Torqu
Page 18 and 19: 4. Mark and drill hole through Beam
Page 20: RSOLARMOUNT-E A HILTI GROUP COMPANY

SOLARMOUNT-E Installation Guide / Manual - Unirac

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?