FIAT Ducato X230 CITROEN Jumper X230 PEUGEOT Boxer X230

INSTALLATION INSTRUCTIONSPACKAGE CONTENTPressures sticker (1X) Pneumatic system instructions (1x)Left suspension (1X)Right suspension (1X)Preassembled brake regulator leverRILSAN KIT :Red pipe (6m) Black pipe (6m)Inflating valves (2x)CLIPS KIT :Plastic clips (10x)LEFT-RIGHT SIDELEFT-RIGHT SIDELEFT-RIGHTSIDELEFT-RIGHTSIDE1234Place the vehicle in ahole or bridge, tooperate SAFE andcomfortably. Unscrewboth, left andright rubber reboundpad and givethem to the enduser.Place the suspensionbetween axle andchassis. Insert the upperslide pin into thehole of rebound pad.Fit RILSAN pipe onpipe fittings of suspensions:• red for right side;• black for left side.Place lower lockingsystem of suspensionon leaf spring lockingclamps.REAR BRAKE REGULATOR MODIFICATIONS INSTRUCTIONSRemove original brake regulatorwithout modify it’s original settings.Deliver at the end user, usermanual and parts removed fromthe vehicle.Mount the provided brake regulatorlever as shown in pict. 14.WARNING : For the execution of the pneumatic system, please strictly refer the specific given instructions. In fact , the system may vary according to the chosenversion (manual, self levelling or electrical); so than the instructions for the pneumatic system are stated in the apposite handbook enclosed at the purchased kit.IMPORTANT: do NOT use liquid Teflon®, hemp, paints etc. .In case of problem and/or information, contact our technical office. In case you fail to comply at this indications,VB-Airsuspension isn’t responsible for eventually damages derivates. For further information contact us.