2008 HB Dodge Durango Owner Manual

WARNING!
Vehicle exhaust contains carbon monoxide, a dangerous
gas. Do not run your vehicle in the garage while
training the transceiver. Exhaust gas can cause serious
injury or death.
Programming HomeLink�
Before You Begin
If you have not trained any of the HomeLink� buttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for 20
seconds. The EVIC will display “CLEARING CHAN-
NELS.” Release the buttons when the EVIC message
states “CHANNELS CLEARED.”
It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 169
to HomeLink� for more efficient training and accurate
transmission of the radio-frequency signal.
Your vehicle should be parked outside of the garage
while training.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1–3 inches (3–8 cm)
from the HomeLink� buttons while keeping the EVIC
display in view.
For optimal training, point the battery end of the handheld
transmitter away from the HomeLink�.
3. Simultaneously press and hold both the chosen
HomeLink� button and the hand-held transmitter button
until the EVIC display changes from “CHANNEL #
TRAINING” to “CHANNEL # TRAINED.”
Then release both the HomeLink� and hand-held transmitter
buttons.
3