HS ACRYLIC LACQUER PRIMER - MyAutoProducts.com

Technical Data Sheet#7501/#7511HS ACRYLIC LACQUERPRIMER SURFACERPRODUCT NUMBER:#7501/#7504 - HS ACRYLIC LACQUER PRIMER SURFACER - GRAY#7511/#7514 - HS ACRYLIC LACQUER PRIMER SURFACER – REDDESCRIPTION:Finish Pro HS Acrylic Lacquer Primer Surfacer is a high quality one component primersurfacer. It offers fast drying and easy sanding with exceptional fill. It can be topcoated withlacquer, enamel and urethane (sealer required) systems.SURFACE PREP:1. Wash area thoroughly with soap and water to remove contaminates that solvent basedcleaners cannot remove effectively.2. Clean repair area with FINISH PRO #6000 Wax and Grease Remover.3. Completely sand surface with 180-220 grit paper and re-clean with FINISH PRO #6000Wax and Grease Remover.4. For maximum adhesion and corrosion resistance, treat bare metal with a quality metalconditioning system or primer.MIXING RATIO (2:3):HS Acrylic Lacquer Primer Surfacer TO LOW VOC REDUCER2 Parts 3 PartsAPPLICATION:Apply 1-3 wet coats at 40-50 psi or (5-10 psi when using HVLP at the gun), allowing a5-10 minute flash between coats. Finish Pro recommends a final blocking with 600 grit orfiner paper before topcoating. For maximum performance, seal HS Acrylic Lacquer PrimerSurfacer before topcoating. NOTE: Film thickness, flash times, and temperatures may effectsanding times.DRY TIMES AT 77° F:FLASHSANDTOPCOAT5-10 MINUTES30 MINUTES30 MINUTESPage 1 of 2

RECOATING:HS Acrylic Lacquer Primer Surfacer may be recoated after a 30 minute dry at 77° F. After 8hours dry time primer must be sanded before topcoating.POT LIFE:Not applicableFISH EYE:Do not use fisheye eliminator in this product.PAINTING FLEXIBLE PARTS:Do not use flexible additives in this product.EQUIPMENT CLEAN-UP:Clean equipment immediately after use with FINISH PRO #6100 Gun Wash Cleaner or#5000 General Purpose Lacquer Thinner.TECHNICAL DATA:Mixing Ratio: 2:3Viscosity (RTS): 18-20 seconds #2 ZahnWeight Solids (RTS): 19.90 - 25.39%Volume Solids (RTS): 9.44 - 12.62%Film Build: 0.8 mils per full wet coatCoverage: 151 - 202 sq. ft. per gallon @ 1 dry milV.O.C. (RTS): 4.6 - 4.9 lbs/galDisposal/Safety: see MSDS for this productNOTE: Finish Pro products are not recommended for use in temperatures below 60° F. Use below these temperatures will effectdry times and performance.FOR INDUSTRY USE ONLYRead MSDS Before UseThe contents of the package must be blended with other components before the product can be used. Any mixture of components willhave hazards of all components. Before opening the packages, read all warning labels. Follow all precautions.The material is designed for application only by professionally trained personnel using proper equipment under controlled conditions, andis not intended for sale to the general public.SEE MSDS AND PRODUCT LABELS FOR ADDITIONAL SAFETY INFORMATION.Page 2 of 2 (Rev. 7/03)