Cercon ceram kiss - DENTSPLY Prosthetics

Instructions for use 2753 54 55or for Touch+Press furnaces, please refer to theAppendix on Page 36.56 575. Divesting: Remove the pressing muffle fromthe pressing furnace immediately at the end ofthe pressing process. Allow the muffle to cooland carefully divest the object. Divesting the objectsand removing residual investment com -pound must be performed only using glass beads(50 µm) at initially 4 bar, reducing to 2 bar as theobject is reached.6. The sprue is now carefully severed from thepressed restoration (Figure 56) using a watercooleddiamond disc. The sprue contacts aresmoothed out using a water-cooled fine-graindiamond. Before veneering, the framework isonce again carefully sand-blasted with glass beads(at 2 bar of pressure) and cleaned with steam.7. The framework thus prepared (Figure 57) canbe veneered directly.