GSM Data Modem Frequently Asked Questions - Scotec - GiSMo ...

command +COPS. Please refer to the AT-Command documentation for detailed informationregarding these commands.2.3 I'm not able to make a call with my GiSMo.- Check if the LED is flashingCheck that you are synchronised on the network with AT+CREG?If yes, the answer should be +CREG : x,1 or +CREG : x,5If not :· check you have properly inserted a SIM card and that you have entered the correct PIN code (forthis AT+CPIN? Should answer +CPIN : READY)· check the signal level with AT+CSQ? (should answer +CSQ : , with RxLevpreferably > 10). In case of weak signal level, check your antenna (connection and band) and yournetwork coverage.· check the status of the "visible" networks with AT+COPS?· Check the status of the locks (SIM lock, network lock,… ) with the AT+CLCK? Command.· check your power supply (see questions on power supply requirements)If you are synchronised on the network :· check you have the appropriate subscription with your network provider (for example, DATA callsrequire to subscribe to a specific DATA service)· for a VOICE call, check that you have issued ATD ; (don't forget the " ; ")· check the status of the Call Barring facility with the AT+CLCK (outgoing call might be barred)· use AT+CEER to get the error cause and check the meaning (network busy, etc) in the ATcommands manual3 CALLS-Fax3.1 How can I send/receive a fax with the GiSMo ?- The GiSMo has been qualified with the following FAX applications only:Delrina Win Fax, MS Win Fax, but it should also work with other FAX applications as well.To configure these applications, please check the GiSMo AT commands manual (FAX section).4 CALLS-Management4.1 How can I know if the remote has answered the call?- Software solution:After sending the ATD command, the GiSMo returns " OK " (or " CONNECT ") only when the remoteparty has answered. You can also use the AT+CPAS or AT+WIND commands. For their use, pleaserefer to the AT Command manual.+CLCC command allows you to know the state of a call (dialling, alerting, active … ).Hardware solution :If you issue a data call, you can use the DCD signal.6