13 - Curriculum Development Centre, Kalamassery

SUBJECT TITLE : WORKSHOP PRACTICE – ISUBJECT CODE : EE 102PERIODS/WEEK : 6PERIODS/YEAR : 192TIME SCHEDULEUNIT TOPIC PERIODSI Carpentry and pattern making 45Test – I 3II Fitting 45Test – II 3III Smithy 45Test – III 3IV Foundry 45Test – IV 3---------Total 192====Note: A Workshop Practice Record should be prepared and certified by the authority. 20% ofInternal assessment must be allotted for this Record.OBJECTIVESUpon completion of the course of study, the student should be able to:1.0 Perform various exercises as per the given drawing and specifications1.1 Identify the required tools from a given number of tools1.2 Select particular tool for a specified operation1.3 Locate the functional part of equipments and tools1.4 Explain the use of tools and equipment1.5 Prepare the edges/work piece as per drawing standard1.6 Set up the job as per the procedures of operation1.7 Perform various steps as per the procedure1.8 Inspect the job for achievement of accuracy and finish1.9 Clean the tools, instruments and work place1.10 Return the tools, instrument as per regulations1.11 Exhibit safety precautionsCONTENT DETAILSUNIT – I: CARPENTRY AND PATTERN MAKINGIntroduction, objectives, safety in the Carpentry shopFamiliarization of toolsMarking and measuring tools such as straight edge, meter square, tri square, bevel square,combination square, marking knife, marking gauge, mortise gauge, cutting gauge, wing compares,trammel divides, outside and inside calipers, spirit level and plumb bob.Cutting tools such as Rip saw, Cross cut saw, panel saw, tenon saw, bow saw, compass saw, key holesaw, firmer chisel, bevel edge firmer chisel, parting chisel, mortise chisel, jack plane, wooden andmetal, trying plane, smoothening plane, rebate plave plough plane, router plave, spoke shave.Boring tools such as Bradawl ratchet brace, wheel brace, shell bit fostries bit, counter sunk bit.Striking tools such as mallet etcHolding devices – Bench vice, bench stop, sash clamp, G-clamp, hard screw.59