DCS-2210/DCS-2230 Quick Install Guide - D-Link

More documents

Recommendations

Info

4 Left Panel Micro SD Card slot Local storage for storing recorded image and video D-Link DCS-2210/DCS-2230 Quick Install Guide
3. Hardware Installation Basic Connection Connect the camera to your switch or router via Ethernet cable. Connect the supplied power cable from the camera to a power outlet. Connection Using a PoE Switch (DCS-2210 only) If using a PoE switch or router, connect the network camera via Ethernet cable. PoE will transmit both power and data over a single cable. Note: Once power has been established, the LED will turn red. When the device has obtained an IP address and is accessible, the LED will turn green. D-Link DCS-2210/DCS-2230 Quick Install Guide 5
Page 1 and 2: Quick Install Guide Full HD PoE/Wir
Page 3: Ethernet The RJ45 connector for Eth
Page 7 and 8: Click on the D-Link Setup Wizard SE
Page 9 and 10: Notes D-Link DCS-2210/DCS-2230 Quic
Page 11 and 12: Notes D-Link DCS-2210/DCS-2230 Quic

DCS-2210/DCS-2230 Quick Install Guide - D-Link

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?