Milling Metric Cat - Jan Havelka

Straight shanks to DIN 6535, Form HAwithout lateral clamping flatfor use in expansion chucksFitting dimensionsEnd mill body with straight shankto DIN 6535/form HA and HBTechnical NotesShank DimensionsSOLID CARBIDEStraight shanks to DIN 6535, Form HBwith lateral clamping flat:One clamping flat for d 1 = 6 to 20 mmWithout centering boreFasewithoutpullingfacewithlateralclampingflat b 1 h 1 h 11 LS l 2 e 1D LS6 36 4,2 5,1 36 - 18,08 36 5,5 6,9 36 - 18,010 40 7,0 8,5 40 - 20,012 45 8,0 10,4 45 - 22,514 45 8,0 12,7 45 - 22,516 48 10,0 14,2 48 - 24,018 48 10,0 16,2 48 - 24,020 50 11,0 18,2 50 - 25,025 56 12,0 23,0 56 17 32,032 60 14,0 30,0 60 19 35,0INSERTSFACE MILLS90˚ MILLSWithout centering boreCut A ASLOTTINGFaseChuck for straight shanks(Form B and Form HB)with lateral clamping flatsFor d 1 = 6 to 20 mmFor d 1 = 25 to 32 mmWithout centering boreFaseFitting dimensionsChucks for straight shanksto DIN 1835 Part 2 /Form B(Extended by d 1 = 14 and = 18 mm)d 1 H5 D d 3 d 4 e 3 e 4 t 1 l 36 25 M 6 8 18,0 - 1,0 358 28 M 8 10 18,0 - 1,3 3510 35 M10 12 20,0 - 1,5 3912 42 M12 14 22,5 - 1,6 4414 44 M12 14 22,5 - 1,6 4416 48 M14 16 24,0 - 1,7 4718 50 M14 16 24,0 - 1,7 4720 52 M16 18 25,0 - 2,1 4925 65 M18x2 20 24,0 25 2,1 5432 72 M20x2 22 24,0 28 2,2 58Recommended torquesfor solid carbide tool shanksclampingscrewM 6M 8M10M12M14M16M18M20INDEXTECHNICAL DATA THREAD MILLS CLASSIC MILLS CERAMIC MILLS DIE AND MOLDtorque5 Nm10 Nm16 Nm28 Nm42 Nm50 Nm60 Nm60 NmTo place an order, contact Kennametal or your authorized Kennametal distributor, or visit www.kennametal.com. 143