Milling Metric Cat - Jan Havelka

Indexable Insert Assembly for FIX-PERFECT Aluminum Milling CuttersIntroduction to Fitting Cutting Bodies32145Roughing indexable insertsBGHX15L5PC..GG.Finishing indexable insertsBGHX15L5PC..GG.1WClean dust, grease, etc., from the insert seat, insert (1), and clamp stud (2).PM HPM/HSM PM/HPM/HSM1? Loosen the adjusting element (4).1? Loosen the adjusting element (4).1? Loosen the adjusting element (4).Loosen the adjusting screw (5).Loosen the adjusting screw (5).Loosen the adjusting screw (5).2? Insert the indexable inserts and tighten with theclamping screw (3). 5 Nm2? Insert the indexable inserts and pre-tighten with 2? Insert the indexable inserts and pre-tighten withthe clamping screw (3). 1,5 Nmthe clamping screw (3). 1,5 NmAttention: Ensure that the insert is correctlypositioned in the insert seat.Attention: Ensure that the insert is correctlypositioned in the insert seat.Determine which cutting body is the highest on the axis.Attention: Ensure that the insert is correctlypositioned in the insert seat.Determine which cutting body is the highest on the axis.3? Tension the adjusting element (4) by tightening 3? Extract by 0,02 mm the insert that is axially the 3? Adjust the finishing indexable insert(s) to thethe adjusting screw (5) to the specified torque of highest by turning the adjusting screw (5).desired projection (preferably 0,04 mm by0,5 Nmturning the adjusting screw (5)).Adjust the remaining inserts to the desired run-outwith maximum travel of the inserts 0,2 mm.0,04 mmAttention: Ensure that the insert is correctlypositioned in the insert seat.4? Clamp the insert by tightening the clamping 4? Clamp the insert by tightening the clampingscrew (3) to the specified torque of 5 Nmscrew (3) to the specified torque of 5 NmCheck the run-outAttention: This process must be repeated whenever an indexable insert is changed. To dismantle, loosen the clamping screw (3) and adjusting screw (5). Then remove the insert (1) with the clamp stud (2).