User manual - Televes -> H45 : Advanced HDTV System Analyzers

By using thewe can move through the list of DATALOGS. Once we have selected ourDATALOG of interest, by pressing the button we can access the results it has stored. Thedata are displayed on a two-column table that shows on the left the sockets measured, and onthe right the results for each socket. By turningsockets of the DATALOG (left col.), and pressingwe will browse through the differentwe will change column (left to right andright to left). Using thewe will be able to move through the column we have selected.Pressing the keywe will return to the list of DATALOGS.3.3.1.6.3.1.- Erasing DATALOGSWith this option we will eliminate the DATALOGS we have selected. For the purpose, onwe will find DATALOGS, selecting and deselecting them with button . The save marked willbe shown in yellow, and then we will press the option CONFIRM ending the erasure operationby once again pressing the buttonscreen.the message "DATALOG ERASED" appearing onWhen a memory is erased or edited, one is also erasing or editing the Macromeasuresin which that memory has been included.The fact of erasing or editing a Macromeasures does not affect the DATALOGS thathave been generated with the erased or edited macromeasure.3.3.1.6.3.2.- Editing DATALOGSFrom this option we can change the name of the desired DATALOG at any moment. For thepurpose, by using thewe can select the DATALOG to be edited, confirming with thebutton. The character selected will blink. Using or the cursors we can changethe selected character. To accept the change, we can press button. Using the cursorsMeasures Config. 55