Cages Installation Details - The Expanded Metal Company

More documents

Recommendations

Info

SECURITY ENCLOSURESMark out lines of the enclosureon the floorStart at one corner or one endand assemble components for acomplete run as illustrated below, theenclosure may need propping inposition.Position the enclosure, then drillinto the floor through the holesin the base angle of the panels,two per panel (10mm masonrydrill)a b c<strong>The</strong> anchor bolts supplied arethen inserted through the baseangle holes into the floor andthe nuts tightened.F OR FURTHER INFORMATION ON ANY OF THE PRODUCTS IN THE E XPAMET S ECURIT
COMPONENTSdefEnsure panel support bracketsare fitted inside angle leg (notbetween panels). Adjust thepanel supports so that thepanels are vertical.Drill the floor through the twoholes in the panel supports(10mm masonry drill) insertthe supplied anchor bolts andtighten.Drill through four of the holesin the side angle when fixingto the wall.Hatch PanelAssembly Panel5 10mm bolts andnuts1 padlockStandard PanelAssemblySide/Roof Panel5 10mm bolts andnuts2 10mmexpanding boltsSINGLE SWING DOOR ASSEMBLYDoor panel2 Hasps2 Door stops2 Hinges + supportbrackets2 10mm Carriagebolts and nuts(hasps)12 Countersunkbolts and nuts(hinges and stops)1 PadlockTop angle (optional)4 BoltsNote: when floors are poor qualityand good panel support fixingsare not possible, or when longruns are required it may benecessary to use extra bracingacross corners, or to the floor, rooftrusses or other structuralsteelwork.DOUBLE SWING DOOR ASSEMBLYDoor panel (left hand)Door panel (right hand)4 Hinges + support brackets2 Door stops20 Countersunk boltsTop angle (optional)4 Bolts1 PadlockY R ANGE, CALL 01429 867366 OR VISIT www.expandedmetalfencing.com
Page 4: DOUBLE SLIDING DOORASSEMBLY2 Door p

Cages Installation Details - The Expanded Metal Company

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?