Cages Installation Details - The Expanded Metal Company

SECURITY ENCLOSURESMark out lines of the enclosureon the floorStart at one corner or one endand assemble components for acomplete run as illustrated below, theenclosure may need propping inposition.Position the enclosure, then drillinto the floor through the holesin the base angle of the panels,two per panel (10mm masonrydrill)a b cThe anchor bolts supplied arethen inserted through the baseangle holes into the floor andthe nuts tightened.F OR FURTHER INFORMATION ON ANY OF THE PRODUCTS IN THE E XPAMET S ECURIT

COMPONENTSdefEnsure panel support bracketsare fitted inside angle leg (notbetween panels). Adjust thepanel supports so that thepanels are vertical.Drill the floor through the twoholes in the panel supports(10mm masonry drill) insertthe supplied anchor bolts andtighten.Drill through four of the holesin the side angle when fixingto the wall.Hatch PanelAssembly Panel5 10mm bolts andnuts1 padlockStandard PanelAssemblySide/Roof Panel5 10mm bolts andnuts2 10mmexpanding boltsSINGLE SWING DOOR ASSEMBLYDoor panel2 Hasps2 Door stops2 Hinges + supportbrackets2 10mm Carriagebolts and nuts(hasps)12 Countersunkbolts and nuts(hinges and stops)1 PadlockTop angle (optional)4 BoltsNote: when floors are poor qualityand good panel support fixingsare not possible, or when longruns are required it may benecessary to use extra bracingacross corners, or to the floor, rooftrusses or other structuralsteelwork.DOUBLE SWING DOOR ASSEMBLYDoor panel (left hand)Door panel (right hand)4 Hinges + support brackets2 Door stops20 Countersunk boltsTop angle (optional)4 Bolts1 PadlockY R ANGE, CALL 01429 867366 OR VISIT www.expandedmetalfencing.com

DOUBLE SLIDING DOORASSEMBLY2 Door panels1 Top bar (double)2 Lengths track size1 Splice plate track7 Support brackets2 Lengths bottom guide4 Sliding door stops at 203/58 Hex bolts and nuts M10 x20 (stops) at 2134 10mm expanding anchors(bottom guide)14 10mm Hex bolts and nuts x25(track fixing)1 PadlockSINGLE SLIDING DOORASSEMBLYDoor panelTop barSliding track4 Track support brackets1 Bottom guide channel2 Sliding door stops2 Hasps4 Hex bolts (stops)2 10mm Expanding anchors(bottom guide)2 10mm Carriage bolts andnuts (hasps)8 10mm Hex bolts and nuts x25 (track brace fixings)1 PadlockPANEL SUPPORT2 Anchor bolts2 10mm Bolts and nutsCAPPING CHANNEL(2440mm Long)4 10mm Bolts and nutsCorner Cleat Assembly4 Cleats4 10mm bolts and nuts.Expamet Security ProductsTHE EXPANDED METAL COMPANY, PO BOX 14, LONGHILL INDUSTRIAL ESTATE (NORTH), HARTLEPOOL, TS25 1PRTEL: 01429 867366 • FAX: 01429 867355 • www.expandedmetalfencing.com