TABLE OF CONTENTS - Martin Archery

SETTING THE CAM TIMINGWheel timing on a two cam bow makes sure the nock travel through the shot isstraight and level. It is important that your bow is timed well for greatest accuracy.Setting the timing is very easy, and you will be able to go through this step by step toset your timing like a pro. First, you will need to draw your bow back to full draw withyour release and an arrow.As you begin to reach fulldraw, slow down and watchthe cable stops roll over tothe cable as seen to the left.You can have a friend checkor you can see it yourself.It is also helpful to performthis test with the bowBoth cable stopsare touching in unison.It is perfect.Twist or TIGHTENthis cable, either fromits loop end or its splityoke (located at theopposite end of thebow.)The top cable stop iscoming to rest beforethe bottom. The top isout of time with thebottom. Put a twist inthe cable that is connectedto the top cam.backed off a few turns. Thiswill make it easier to holdwhile you are checking thecable stops. If your camslook like the ones to thefar left, they are perfectlytimed. If one touches beforethe other, as seen on theright, you will need to twistor TIGHTEN the cable thatis connected to the camthat stops first. Relax thebow in a bowpress beforeattempting to make anyadjustments. You can adjustthe cam's rotation usingtwo methods; follow thatcam's cable to its split yokeand make adjustments thereby removing and twistingthe yoke, or disconnect the cable from its peg on the cam and twist. This will changethe cam's rotation a little to get it in sync with the other. Only twist one or two twists ata time. A little twisting goes a long way. Once you get rotation close, you can put a halftwist in the cable to get it perfect if needed. Try not to over complicate this procedure;it is as simple as it sounds.USING NITROUS MINI-MODULESIn some cases your draw length will be at the shortest end of the cam's draw lengthadjustment range. Using a Mini Module will give you two more inches down on anyof the Nitrous Cam bodies, and it will give you better performance in the short drawlengths. See your local dealer for a set of Mini Modules if you are in the last two drawlength settings. The Mini Module will give you more draw length flexibility.6