Use of the Binocular Microscope

More documents

Recommendations

Info

Step #1Put the lowest power objective lens into place.Notice that all the objective lenses turn on a turretand that they click into place.As a general rule always use the lowest power objective lensto find your specimen.On the microscope in front of you, this is the 4X lensand is the shortest.Turn this lens into place.
Step #2Now place the specimen on the stage.Notice that the slide is held in a clip on the stagewith the specimen side up.The clip is adjustable and holds the slide firmly in place.Pull back the clip and slip the glass slide into placeon the stage as shown in the next slide.Make sure that the clip is not on top of the slide,but holds it firmly in place.
Page 1: Use of the BinocularMicroscope
Page 5 and 6: Part IThe parts of a typical binocu
Page 7: Turret headStageStageadjustmentknob
Page 10 and 11: The lens that has 40xmagnification
Page 12 and 13: You should always double checkby re
Page 14 and 15: The microscope has two focusing kno
Page 16 and 17: The next few slides identify the co
Page 18 and 19: Schematic diagram of the opticsof a
Page 20 and 21: The diaphragm isclosed down.The dia
Page 22 and 23: This is the end of Part I
Page 26 and 27: The specimen on the prepared slide
Page 28 and 29: Note that there are micrometer read
Page 30 and 31: Step #4Looking through only the RIG
Page 32 and 33: Step # 6Now you will adjust the bin
Page 34 and 35: First cover your left eye.Looking t
Page 36 and 37: Step # 9Close the diaphragm as far
Page 38 and 39: Step # 11Once the condenser is adju
Page 40 and 41: Step # 12Change to the 10X lens by
Page 42 and 43: Remember that when you change objec
Page 44 and 45: Place a drop of immersion oil on th
Page 46 and 47: Now adjust the fine focus, diaphrag
Page 48 and 49: 3. Using lens paper, carefully clea
Page 50: When carrying a microscope always u

Use of the Binocular Microscope

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?