CLUBTORQUEsure on Evan at every test, but when the final scores were tallied, Evan triumphedby a micro margin of only 6 tenths of a second.Ringwood Park Hill Climb is a neat and friendly venue and the canteen sure cancook a tasty sausage sizzle. Round 2 of the State series was a roaring successwith all drivers achieving just enough of an adrenalin rush to tie them over untilthe next event. Congratulations to the winners, all competitors, <strong>MG</strong> <strong>Car</strong> <strong>Club</strong> asthe host, CAMS officials and volunteers for making the event a success.Krystal Hardenwww.snakeracing.com.auPage 32
FOR SALE Khanacross buggyPrice $12,500 onoThe design was by Arthur Jackson.The owner Graeme Lomas built the carin 2002. The buggy has been used inNSW State Khanacross Championshipevents between 2002 and 2006 andgained a number of Outright top threeplacings. The car is ready to run as is.Fuel used must be 98 octane (no alcoholsupplement like Shell V Power). ASuzuki Cultus (Japanese version of SuzukiSwift GTi) front cut was purchasedin 2001. It included the engine, radiator,gearbox, axles, front brakes, wiringharness and ECU. The engine andgearbox are in standard form. It has afiddle handbrake which can lock one orthe other rear wheel. The trailer is alightweight full metal construction unsprungtrailer (hot dipped galvanised).Contact Graeme Lomas 0407 912 798or Michael Snow 0432 772 044FOR SALE Pirahna HC1 Formula LibreGet ready and racing for the upcomingTri Series, competitive hillclimb carpowered by Suzuki GSXR 1100 withbig bore kit to 1218 cc, head ported, Mikuniflatslide carbies, near new Quaifehellicoil diff, some spares, 2 sets ofwheels, enclosed tilt trailer with electricwinch made to suit car, bargain price$16,500.Contact Ed McCane 02 4938 9352 or0418 275 403CLASSIFIED ADS<strong>Apr</strong>il <strong>2011</strong>FOR SALE unfinished project LMPRear engine specialDesigned from chassis up, front andrear uprights and many other parts machinedfrom block alloy, all suspensionarms and joints hand fabricated fromstainless tube, new Gen 111 5.7 litrealloy engine with hand fab extractors,12" rear and 10" front billet rims fromUSA, too many other parts to list, manythousands of $ spent so far, ready for adedicated person to complete, reasonablegenuine offers will be considered.Contact Ed McCane 02 4938 9352 or0418 275 403Page 33