Download Manual - Scag Power Equipment

Section 1GENERAL INFORMATION1.1 INTRODUCTIONYour mower was built to highest standards in the industry.However, the prolonged life and maximum efficiency ofyour mower depend on you following the operating,maintenance and adjustment instructions in this manual.If additional information or service is needed, contact yourScag Power Equipment Dealer.We encourage you to contact your dealer for repairs. AllScag dealers are informed of the latest methods to servicethis equipment and provide prompt and efficient service inthe field or at their service shop. They carry a full line ofScag service parts.USE OF OTHER THAN ORIGINAL SCAGREPLACEMENT PARTS WILL VOID THEWARRANTY.When ordering parts, always give the model and serialnumber of your tractor and cutting deck. The serial platesare located where shown in Figure 1-1.For pictorial clarity, some illustrations and Figures in thismanual may show shields, guards or plates open or removed.Under no circumstances should your mower be operatedwithout these devices in place.All information is based upon product information availableat time of approval for printing. Scag Power Equipmentreserves the right to make changes at any timewithout notice and without incurring any obligation.1.2 DIRECTION REFERENCEThe “Right” and “Left”, “Front” and “Rear” of the machineare referenced from the operator’s right and left when seatedin the normal operating position and facing theforward travel direction.1.3 SERVICING THE ENGINE AND DRIVETRAIN COMPONENTSThe detail servicing and repair of the engine, hydraulic pumpand motors and gear boxes are not covered in this manual;only routine maintenance and general service instructionsare provided. For service of these components during thelimited warranty period, it is important to contact your Scagdealer or find a local authorized servicing agent of thecomponent manufacturer. Any unauthorized work done onthese components during the warranty period may void yourwarranty.Tractor Serial NumberPlate LocationCutter DeckSerial NumberPlate LocationFigure 1-1 Serial Plate Locations1