LumeLEX 2024 SERIES INSTALLATION INSTRUCTIONS THIS ...

Aiming theSelf-LockingandWrench-LockingFixturesBefore Aiming: For self-locking fixtures, you donot need an external locking device to set thehorizontal and vertical focus. For wrench lockingfixtures, use the supplied Allen key (3/32 inches) toset and lock the horizontal and vertical focus.STEPACTION1 Turn off all power to the fixture,including the fixture switch on thefitting, and let the LED cool.WARNING: LED and fixture may behot.2 Do you want to aim the fixturehorizontally or vertically?• For horizontal aiming, hold theballast housing and turn it left orright until you achieve your desiredorientation (Fig. 10).• For vertical aiming, hold the LEDhousing and angle it up and downuntil you achieve your desiredorientation (Fig. 11).• For wrench locking: After aiming,insert the Allen key into thehorizontal or vertical focus lock(Fig. 12), and turn it clockwise totighten.Note: For track and busway fixtures,the Allen key is stored in the fittinghandle (Fig. 13).3 Restore power.WARNING: Do not look directly atthe lit LED.Figure 10. Turn fixture left or right to set thehorizontal focus.Figure 11. Angle fixture up or down to set thevertical focus.Figure 13. Allen key storage in fitting.Push in to secure the key.Figure 12. Horizontal focus lock (top arrow).Vertical focus lock (bottom arrow).www.LightingServicesInc.com Page 5 of 6 IS-0103_D