LEADTEK Wireless GPS Receiver User's Manual

More documents

Recommendations

Info

.(5) After searching, the found devices will list. Click on the target to find service. Ifthe SPP service is found, the service name will be shown in Device frame. Thenselect the target service and click “Next”.(6) After the previous steps, the wizard will show the message to tell the user that thelink shortcut has been established. It means that the user could see the shortcut inthe Bluetooth Manager.- 16-
.(7) Select the target and hold on it for a while, then the sub-menu will pop-up. Select“Connect” to establish the link. If successes, the icon of target device will turninto green. As the connection has been established, application could open theport.BTW-CE 1.3 won’t remember the last linked device. Instead, when the application try toopen the outbound port, if the port is not link to the target previously, then the BluetoothManager will pop-up. And the user would select the shortcut of the target device to- 17-
Page 1 and 2: .LEADTEK Wireless GPS ReceiverUser
Page 3 and 4: .1. Introduction1.1. OverviewThe Le
Page 5 and 6: .Output messageDefault output forma
Page 7 and 8: .LED2GPS & Charge LEDDescriptionLED
Page 9 and 10: .5.5 BatteryThis product uses a Lit
Page 11 and 12: .2. BTWCE 1.1(1) Make sure that the
Page 13 and 14: .(5) Back to the main form of BTW-C
Page 15 and 16: .(7) As the connection being establ
Page 17: .(3) Click the “Bluetooth Manager
Page 21 and 22: .Step 2.The Add/Remove Programs dia
Page 23 and 24: .Step 5.When the installation is co
Page 25 and 26: .you have to get the authorized sof
Page 27 and 28: . In the Folders pane of My Bluetoo
Page 29: .Leadtek Research Inc.: 18F, 166, C

LEADTEK Wireless GPS Receiver User's Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?