12.07.2015 Views

DeltaSol BS Plus - Ika

DeltaSol BS Plus - Ika

DeltaSol BS Plus - Ika

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

<strong>DeltaSol</strong> ® <strong>BS</strong> <strong>Plus</strong>4.1.18 Thermostat function (Arr = 3)Afterheatinguse of surplus energyThe thermostat function works independently from thesolar operation and can e.g. be used for the use of surplusenergy or after-heating. < the thermostat function is used for after-heating > the thermostat function is used for use of surplusenergySymbol will be shown on the display if the secondrelay output is activated. Thermostat-switch-ontem peratureAdjustment range:0,0 ... 95,0 °CFactory setting: 40,0 °Ct1 E, t2 E, t3 E:Thermostat switch-on timeAdjustment range:00:00 ... 23:45Factory setting: 00:00 Thermostat-switch-off temperatureAdjustment range:0,0 ... 95,0 °CFactory setting: 45,0 °Ct1 A, t2 A, t3 A:Thermostat switch-off timeAdjustment range:00:00 ... 23:45Factory setting: 00:00In order to block the thermostat function for a certaintime span, there are 3 time frames t1 ... t3. If the functionshould be activated only between e.g. 6:00 and 9:00, 6:00should be set for t1 E and 9:0 should be set for t1 A. Thefactory setting for the thermostat function is in continuousoperation.If all time frames should stop at 00:00 o’ clock, the thermostatfunction is continuously in operation(factory setting). nMN, n1MN, n2MN:Pump speed controlAdjustment range:30 ... 100Factory setting: 304.1.20 4.1.20 Operating modeOperating modeAdjustment range:OFF, AUTO, ONFactory setting: AUTO LANG:Adjustment of languageAdjustment range: dE, EnFactory setting: En| 20A relative minimum pump speed is specified for pumpsconnected at the outputs R1 and R2 via adjustment channelsnMN, n1MN and n2MN.Attention: not pump speed controlled, the value must be setto 100 % in order to deactivate the pump speedcontrol.For control- and service works the operating mode ofthe controller can be manually adjusted by selecting theadjustment value MM in which the following adjustmentscan be made: Operating modeOFF : relay off (blinking) +AUTO : relay in automatic operationON : relay on (blinking) +The menu language can be adjusted in this channel. dE : German En : English© NEHS_07333_deltasol_bs_plus.mon.indd

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!