DeltaSol BS Plus - Ika

More documents

Recommendations

Info

DeltaSol ® BS Plus1. Installation Warning!1.1 Mounting opening the housing.displaycoverpushbuttonThis unit must only be located internally. It is not suitablefor installation in hazardous locations and should not besited near to any electromagnetic field. The controller mustadditionally be equipped with an all-polar gap of at least 3 mmor with a gap according to the valid installaton regulations,e.g. LS-switches or fuses. Please ensure sensor cables andac power supply are separatedcable conduits with strainrelieffasteningcan fuse 4A1. Unscrew the cross-head screw of the cover and removeit from the housing.2. Mark the upper fastening point on the subsurfaceand premount the enclosed dowel and screw.3. Mount the housing to the upper fastening point and markthe lower fastening point on the subsurface (pitch of hole130 mm), afterwards set the lower dowel.4. Mount the housing to the top and fix it with the lower.fastening screw..fixing1.2 Electrical connection| 4Temp. SensorPt1000S1 S2 S31 2 3 4 5 6Sensor clampS4 VBus7 8 910 12 13 14VBusground clampDangerous voltage on contact!fuseT4A220 ... 240 V~R1 1 (1) A ( 220 ... 240) V~R2 1 (1) A (220 ... 240) V~N R2 N R1 N L15 16 17 18 19 20consumer clampsnet clampsPlease note:The relays are semi-conductor-relays for pump speed control - they needa minimum load of 20 W (power consumption of the consumer) forfaultless function. When connecting auxiliary relays, motor valves, etc. areindividually to the condenser which is enclosed in the mounting material,must be connected parallely to the relevant relay output.Attention: for connection of auxiliary relays or valves, the minimum pumpspeed must be adjusted to 100 %.Electrostatic discharge can lead to damages of electroniccomponents!The power supply to the controller must only be made by anexternal power supply switch (last step of installation!) andthe line voltage must be 220 ... 240 Volt (50...60 Hz). Flexiblelines are to be fixed at the housing by enclosed strain reliefsupports and screws.The controller is equipped with 2 standard relays, to whichthe consumers e.g. pumps, valves etc. can be connected: 18 = conductor R117 = neutral conductor N13 = ground clamp 16 = conductor R215 = neutral conductor N14 = ground clampThe temperature sensors (S1 up to S4) will beconnected to the following terminals independently of thepolarity:1 / 2 = Sensor 1 (e.g. Sensor collector 1)3 / 4 = Sensor 2 (e.g. Sensor store 1)5 / 6 = Sensor 3 (e.g. Sensor collector 2)7 / 8 = Sensor 4 (e.g. Sensor store 2)The power supply is effected to the clamps:19 = neutral conductor N20 = conductor L12 = ground clamp© NEHS_07333_deltasol_bs_plus.mon.indd
DeltaSol ® BS Plus The controller comes with a VBus ® for data commmunicationand energy supply of external modules. Theconnection is effected with optional polarity at the clampsmarked with„VBus“. Via this data Bus you can install one ormore VBus ® modules, e.g.:VBusconnection clamps Additionaly, the controller can be connected to the PC withthe help of a RS-COM adapter. With the SERVICE CEN -TER SOFTWARE (R C S) the controller parameterscan be changed, measurements can be read out, processedand visualised. The software enables an easy function controland adjustment of the system.1.2.2 Allocation of clamps for system 1 Standard solar system with 1 store, 1 pump and 3sensors. Sensor S4 / TRF can optionally be used for heatquantity balancing.Arr 1S1© NEHS_07333_deltasol_bs_plus.mon.inddR1S4 / TRLS3S2SymbolS1S2S3S4 / TRLR1collector sensorlower store sensorupper store sensor(optional)sensor for heat quantitymeasurement (optional)solar pump5 |
Page 1 and 2: *48000500*48000500DeltaSol ® BS Pl
Page 3: DeltaSol ® BS Plus Pt1000
Page 7 and 8: DeltaSol ® BS Plus1.2.5 Allocation
Page 9 and 10: DeltaSol ® BS Plus1.2.8 Connection
Page 11 and 12: DeltaSol ® BS Plus2.2.3 System scr
Page 13 and 14: DeltaSol ® BS Plus4. Control param
Page 15 and 16: DeltaSol ® BS Plus4.1.1 Indicataio
Page 17 and 18: DeltaSol ® BS Plus4.1.8 DT E / DT1
Page 20 and 21: DeltaSol ® BS Plus4.1.18 Thermosta
Page 22 and 23: DeltaSol ® BS Plus5.1 VariousPump
Page 24: DeltaSol ® BS Plus6. AccessorySens

DeltaSol BS Plus - Ika

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?