Technical Data Sheet fischer fixit 2K Epoxy modelling putty 2K EK

Technical Data SheetApplicationFills holes and grooves, repairs faulty bores and seals holes in tanks, drums, pipes, etc.. Suitable formetal, ceramic, stone, concrete, plastic and wood.Not suitable for PE, PP, Teflon®, acrylic glass and to repair pressurised pipelines.May be used under water and on damp application surfaces.Properties / Features- Bond, Repair, Fill, Seal- Model- May be drilled, ground and milled- Paint able- Withstands temperatures up to +150°CSurface cleaningThe parts to be joined together must be clean and free of oil and grease.Directions for useThe parts to be joined together must be clean and free of oil and grease.Lightly roughen the surfaces to improve adhesion.Cut off the required amount and knead it until a uniform colour is achieved and the material becomeswarm. Apply the putty to the parts and model; let rest for at least 20 minutes.When working under water, apply pressure to the material until it begins to harden.Do not use the putty in outside temperatures below +5°C.We recommend wearing protective gloves when working with the material.The product may be worked in as little as approx. 20 minutes (drilling, tapping and threading, filing,sandblasting, milling, sawing). Fully hardened after about 3 hours.CleanupBefore hardening – with cleaning solvent or acetone, after – mechanical cleaning.StorageStore at room temperature.Chemical resistanceThe putty is resistant to oils, fuel and many more.version: 1/2008-04-01/TDB114GB page 2/3