ss-250 series stainless steel slide gate - Waterman Industries

PART 3EXECUTION3.01 INSTALLATIONA. Installation of the slide gates shall be done in a workmanlike manner. It shall be theresponsibility of the CONTRACTOR to handle, store, and install the equipment specified inthis Section in strict accordance with the Manufacturer’s recommendations.B. The CONTRACTOR shall review the installation drawings and installation instructions prior toinstalling the slide gates.C. The slide gate frames shall be installed in a true vertical plane, square and plumb, with notwist, convergence or divergence between the vertical legs of the guide frame.D. The CONTRACTOR shall fill any void between the guide frames and the structure with nonshrinkgrout as shown on the installation drawing and in accordance with the groutmanufacturer’s recommendations.3.02 FIELD TESTINGA. After installation, all slide gates will be field tested in the presence of the ENGINEER andOWNER to ensure that all items of equipment are in full compliance with this Section. Eachslide gate assembly shall be water tested by the CONTRACTOR at the discretion of theENGINEER and OWNER, to confirm that leakage does not exceed the specified allowedleakage.END OF SECTIONNOTHING FOLLOWS• GNI Waterman LLC • P.O. Box 458 • 25500 Road 204 • Exeter, California 93221 • Phone (559) 562-4000 • FAX (559) 562-2277 •24