12.07.2015 Views

ACS OnSite Aparato A&E Specifications - Brivo Systems

ACS OnSite Aparato A&E Specifications - Brivo Systems

ACS OnSite Aparato A&E Specifications - Brivo Systems

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Page 5 Architectural and Engineering <strong>Specifications</strong>: <strong>Aparato</strong> ®c. The system shall include the capability to utilize back-up facilities fromauthorized Internet hosting services and shall use SSH encryption fortransmission of encrypted back-up file.8. Network Communicationsa. The <strong>ACS</strong> shall utilize Ethernet communications as its primarycommunications medium and shall conform to IEEE 802.3 industrystandards for typical computer based network connectivity.1) Ethernet connections shall use industry standard 8P8C modularconnectors and shall conform to TIA/EIA-568-B wiring standards.b. The <strong>ACS</strong> appliance shall include support for the following minimumnetwork configuration settings:1) DHCP2) Static IP Addressi) Internet Protocol version 4 (IPv4)3) Network Mask4) Gateway Address5) Primary DNS6) Secondary DNSc. The <strong>ACS</strong> shall support static route configuration as required. Configurationentries shall include, but not be limited to, the following settings:1) Destination IP Address2) Gateway3) Network Mask9. Security Door Controller (SDC)a. SDCs shall represent multiple door controller devices including, but notlimited to:1) Multi-Door Controller Hubi) SDCs multi-door controller hubs shall be fully expandable from aminimum of 1 reader up to 30 readers.ii) SDCs shall include a UL-listed chassis and power supply designedto accommodate a variety of expansion options.iii) SDCs shall include the ability to maintain a minimum of 25,000cardholders.2) Independent Edge Controller (IEC).i) Each IEC shall have the ability to maintain a minimum of 25,000card holders and a minimum of 5,000 off-line events.ii) IECs shall include Power-over-Ethernet (PoE) capabilities, withthe ability to supply at least 700mA of auxiliary power for externallock and/or REX devices.iii) IEC PoE shall conform to the IEEE 802.3af standard.b. The <strong>ACS</strong> shall provide a seamless programming environment and shall fullyintegrate IECs and SDCs as integral components of the system.c. Communications options shall include:1) 10/100Mbs Ethernet.2) CAN Bus - Use CAT5 (or higher) UTP cable up to 1,500 feet.C. Accounts© 2013 <strong>Brivo</strong> <strong>Systems</strong> LLC. All rights reserved. 7/1/2012

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!