J Series brochure. - Christie Digital Systems

technical specificationsImage brightness • 6200 ANSI ANSI lumens(6850 center lumens) @ 220V• 4650 ANSI lumens(5100 center lumens) @ 110VDisplaytechnologycontrastMirage WU7K-J Mirage S+22K-J Mirage HD14K-J Mirage HD16K-J Mirage HD20K-J• 1600-2000:1 full field | 650:1 ANSI• 20,000 ANSI lumens(22,000 center lumens)• 12,000 ANSI lumens(13,200 center lumensuniformity • 80% brightness uniformity • 90% brightness uniformity • 80% brightness uniformitytype • 3-chip 0.96" DMD • 0.95" DMDnative resolution • WUXGA (1920 x 1200) • SXGA+ (1400 x 1050) • HD (1920 x 1080)frame delay• As low as one frameLamp type • 1.0kW Cermax Xenon pre-aligned lamp module • 3.0kW Xenonbubble lamp module• 2.0kW Xenonbubble lamp module• 14,000 ANSI lumens(15,400 center lumens]• 2.4kW Xenonbubble lamp moduleestimated life • 1500 hrs • 750 hrs • 1000 hrs • 750 hrs • 750 hrsInput standard • Slot 1-2 populated, standard: two Dual Link DVI-D (330 MHz) input cards (each has VGA (165 MHz) for 3D or dual input 3D compatibility) with HDMI 1.3 receiver Slot 3-4 unpopulatedoptionalsignalspixel clockscan ratesControl and networkingOptical system• Analog • Dual link DVI • Dual 3G SD/HD-SDI • Video decoder • Twin HDMI• 18,000 ANSI lumens(20,000 center lumens)• 3.0kW Xenonbubble lamp module• HDTV formats VGA through to QWXGA (2560 x 1600) • Accepts all current 2D HDTV/DTV formats (optional input cards may be required)• HDMI 1.3 receiver supports mandatory HDMI 1.4a 3D modes of operation plus 24-144Hz triple flash 3D mode • Multi-standard video decoder • Horizontal and vertical scaling, all inputs• 330 MHz• Horizontal: 15-120kHz • Vertical: 23.97-150Hz (frame lock maximum 120Hz) • 48-60Hz frame doubled or dual input 3D • 48Hz (24Hz per eye) frame triple flash• 96-120Hz frame rate up to 1920 x 1200 • 24-144Hz triple flash 3D• RS232 in/out • RS422 in • Ethernet (10/100) • USB Device • GPIO (RS232 9 Pin male connector) • Built-in backlit LCD keypad • Remote control (with optional wired XLR connection)• Dust-sealed 3-chip DMD light engine • Motorized horizontal and vertical lens offset • Scheimpflug/Boresite (tilt) adjustment • Built-in light shutter • Tool-free lens insertion systemLenses fixed • ILS Lens 0.73:1 SX+ / 0.67:1 HD* • ILS Lens 1.2:1 SX+ / 1.1:1 HDzoom • ILS Lens 1.25-1.6:1 SX+ / 1.16-1.49:1 HD** • ILS Lens 1.5-2.0:1 SX+ / 1.4-1.8:1 HD • ILS Lens 2.0-2.8:1 SX+ / 1.8-2.6:1 HD • ILS Lens 2.8-4.5:1 SX+ / 2.6-4.1:1 HD• ILS Lens 4.5-7.5:1 SX+ / 4.1-6.9:1 HD • ILS Lens 7.5-11.2:1 SX+ / 6.9-10.4:1 HDoffsets• ±112% Vertical • ±54% Horizontal• (* ±22%V ±6%H) • (** ±82%V ±38%H)Accessories standard • IR remote • Line cordoptionalEnhanced feature setsPowerrequirements(Dual lampmode)• ±100% Vertical • ±50% Horizontal• (* ±23%V ±13%H) • (** ±70%V ±45%H)• ±120% Vertical • ±54% Horizontal• (* ±35%V ±12%H) • (** ±102%V ±40%H)• ILS lens adapter kit • CT lens mount 1 • Yellow notch filter 1 • 3D glasses (active and passive) • 3D active emitter • 3D passive modulator • Fog juice filters 2 • DMX512 interface card• Analog input card • Dual link DVI input card • Dual 3G SD/HD-SDI input card • Video decoder input card • Twin HDMI input card • Remote IR sensor • Bulb alignment tool 2 • Bare bulb kit 2• Ceiling mount • Ceiling mount extension • Stacking kit 3• Embedded Christie Twist • Embedded image tiling • Intelligent Lens System (ILS) • Advanced block artifact reduction • ChristieNET web interface • User-friendly, intuitive LCD keypad• Advanced loop-through Twin HDMI card • Lamp memory module • User replaceable bulbs (2.0kW, 2.4kW and 3.0kW only) • Advanced 10-bit processing • Automatic shut-off and ECO mode• Dust-sealed light engine • SNMP (simple network management protocol) • DHCP (dynamic host configuration protocol) • Liquid cooling ( 2.0kW, 2.4kW, 3.0kW models only)• Setup lights (2.0kW, 2.4kW, 3.0kW models only) • Hybrid stack • Compatability with legacy accessoriesoperating voltage • 100-240 VAC @ 50/60Hz • 200-240 VAC @ 50/60Hzmaximum operating current • 12A @ 100-120V • 8A @ 200-240V • 20A @ 200V • 14A @ 200V • 16A @ 200V • 20A @ 200Vpower • 1600W • 4000W • 2800W • 3200W • 4000Wdissipation • 5460 BTU/hr • 13,650 BTU/hr • 9560 BTU/hr • 10,925 BTU/hr • 13,650 BTU/hrDimensions size • (LxWxH): 22.3 x 26.0 x 12.9" (566 x 660 x 328mm) • (LxWxH): 32.0 x 24.5 x 16.5" (815 x 621 x 419mm)shipping size • (LxWxH): 33.5 x 30.0 x 26.0" (851 x 762 x 660mm) • (LxWxH): 41.0 x 32.5 x 29.5" (1041 x 825 x 749mm)weight • 88lbs (40kg) (without lens) • 160lbs (72.5kg) (without lens)shipping weight • 125lbs (57kg) • 200lbs (91kg)Operating environment• Temperature: 40-104°F (5-40°C) • Humidity: 20-80% non-condensingRegulatory approvals • Regulatory Approvals/Markings: Directives (EC) 2011/65/EU (RoHS); 2012/19/EU (WEEE); Regulation (EC) No. 1907/2006 (REACH) • CAN/CSA C22.2 No. 60950-1• UL 60950-1 • IEC 60950-1 • FCC, Part 15, Subpart B, Class A • EN55022/CISPR22 Class A• EN55024 / CISPR24 • Certifications marks (check with CDS for latest update): cULus (Canada & US), CE (EU), CCC (China), GoST-R (Russia), KC (Korea), PSE (Japan),C-Tick (Australia & New Zealand), South AfricaLimited warranty• Three years parts and labor (including light engine)1 Factory installed at time of purchase.2 Does not apply to Mirage WU7K-J.3 Only applies to Mirage WU7K-J.4 Dimensions A, B and C are based on the lens being used.17