TWO BURNER PROPANE CAMPING STOVE - Brinkmann

More documents

Recommendations

Info

Step 1Snap down legs to form a "V" with the stovebase.Notched Support ArmStep 2Open lid and align the two wind guards byinserting notched support arms into windguards.Step 3Remove regulator/valve assembly.Regulator KnobBurner Control KnobsRegulator/ Valve AssemblyWARNING: Always snap down legs to form a "V" with the stovebase to prevent the stove from becoming unstablewhile in use.Step 4Before attaching propane cylinder, makesure the regulator and burner control knobsare in the "OFF" position.Step 5Attach propane cylinder to regulator/valveassembly by turning propane cylindercounter-clockwise. HAND TIGHTEN ONLY.NOTE:Use propane cylinder upright whenpossible to prevent flare-ups.Step 6Attach regulator/valve assembly to stovefitting. HAND TIGHTEN ONLY.Stove Fitting3
GAS LEAK TESTINGTHE GAS LEAK TESTING PROCEDURE MUST BE PERFORMEDEVERY TIME THE CYLINDER IS CONNECTED TO STOVE.WARNING• Gas leak testing must be performed outdoors in a well ventilated area.• During the gas leak testing procedure, always keep unit away from open flames, sparks or lit cigarettes.• Never use a flame to check for gas leaks.• Always use the regulator valve knob to turn the unit "OFF". The control knobs are used when lighting the burnersand to adjust the flame.• Never use a unit that has a gas leak. Contact The Brinkmann Corporation’s Customer Service Department forreplacement parts at 1-800-527-0717.Step 1Make sure the regulator knob and control knobs are inthe "OFF" position.Step 2Make sure regulator/valve assembly is properly attachedto propane cylinder refer to "Assembly Instructions".Attach regulator/valve assembly to the side of theCamping Stove. HAND TIGHTEN ONLY.Step 3Prepare a soapy water solution (one part dishwashingliquid to three parts water) to test for gas leaks in theassembly hose and connections. Apply a generousamount of the soapy mixture to the regulator stem, theentire length of hose and Camping Stove fitting (locatedon the right side of stove).Step 4With the control knobs in the "OFF" position, open theregulator valve two full turns (counter-clockwise). Next,check for bubbles at regulator valve, along the entirelength of hose and at the Camping Stove fitting. DO NOTLEAVE GAS ON FOR MORE THAN 10 SECONDS. If soapymixture starts bubbling, gas is leaking through theconnection or hose. Turn the regulator valve "OFF" andretighten the connection that is leaking gas. Repeatprocedure with soapy mixture until gas no longer leaks.NEVER USE A FLAME TO CHECK FOR GAS LEAKS. Turnthe regulator valve "OFF" after each test.Step 5Once all gas leaks have been sealed, WAIT AT LEAST 5MINUTES FOR GAS FUMES TO DISSIPATE BEFORELIGHTING THE BURNERS.Carefully follow "Operating Instructions" to light theburner and properly operate this unit.Regulator/ ValveAssemblyNOTE:Stove FittingUse propane cylinder upright whenpossible to prevent flare-ups. Makesure not to cross-thread fittingswhile tightening.Watch for BubblesPropane Cylinder Valve4
Page 1 and 2: OWNER’S MANUALASSEMBLY AND OPERAT
Page 3: WARNING• Keep hands, face and hai
Page 7 and 8: AFTER-USE SAFETYWARNING• Always a

TWO BURNER PROPANE CAMPING STOVE - Brinkmann

Create successful ePaper yourself

Delete template?

Save as template?