OPERATING INSTRUCTIONS for vinyl cutters Secabo C30III, C60III ...

More documents

Recommendations

Info

6.4 ChangingYou can make the following changes in the online mode by pressing thecorresponding buttons:Increase speedReduce speedIncrease pressureReduce pressureThe cutting speed and contact pressure cannot be changed while a plotting job is inprogress.6.5 Repeat FunctionAfter conclusion of a job it can be repeated without having to transfer the data fromthe computer again. For this purpose ensure that the vinyl cutter is in the offlinemode and press the Repeat key.13
6.6 Other SettingsIt is possible to scroll through other configuration menus in the offline mode bypressing the menu key a number of times.In the settings menu it is possible to adjust the idle speed of the cutting head (Ur), aswell as the Baud rate (Br). The Baud rate set must be identical with the Baud rate seton the computer. This value must be set to 38400.The vinyl cutter can be calibrated correctly in the scaling menu (Set Per). Correctionmay be required here due to wear to the mechanical parts. The X and Y scaling ofthe data can be changed by changing the Xp and Yp values. If, for example, anobject entered with a length of 100 cm on the computer is cut on the vinyl cutter toa length of only 98cm, it is necessary to correct the corresponding scaling value onthe plotter.38400Otherwise, these values should not be changed.6.7 Limit SwitchesIf a plotting job is sent to the vinyl cutter accidentally which is larger than themaximum cutting width of the plotter, the cutting head is stopped automatically by asensor at the left and right sides. In this case, the vinyl cutter is reset and it isnecessary to transfer the job to the plotter again.14
Page 1 and 2: OPERATING INSTRUCTIONSfor vinyl cut
Page 3 and 4: 1 Safety PrecautionsPlease read the
Page 5 and 6: 3 Layout of Stand-Up-BaseTools requ
Page 7 and 8: hgfa) Online-/Offline buttonb) Test
Page 9 and 10: 5.3.1 Installation of the device dr
Page 11 and 12: • Press the pin on the rear of th
Page 13: 6 Settings and Operation6.1 Online/
Page 17 and 18: 8 Technical DataModel C30III C60III
Page 19: KonformitätserklärungStatement of

OPERATING INSTRUCTIONS for vinyl cutters Secabo C30III, C60III ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?