decomagazine - Tornos

ack operation spindles, which are both powerfuland highly responsive. The combination of these twocomponents enables balanced setup between thetwo sides of the workpiece being machined, and theproduction of relatively complex workpieces for sucha “simple” machine’. Three tools can be engagedsimultaneously in the material. Back operations areperformed in concurrent operation time, while platten1 allows work to continue on the guide bush.A high-tech spindleEntirely developed and produced in Moutier, thesynchronous type spindle delivers 9.5 kW as well assuper-fast acceleration and deceleration (from 0 to10,000 rpm in 0.9 seconds). It is by far the most powerfuland responsive machine on the market in thisproduct category. Equipped with an integrated coolingsystem, the spindles contribute to the machine’sthermal stability. This results in increased precision.THREE OFFERINGS FORTHREE PRODUCT CATEGORIESThe Swiss ST 26 is offered as standard in threeversions : Starter, Advanced and Medtech.These three packs include a variety of equipmentsuited to the type of workpieces to beproduced. Depending on the requirements, thecompany can also supply additional equipment :chip conveyor, high pressure pump or oil mistextractor. Mr. Villard continues : “We are obviouslynot in the same league as the EvoDeco interms of the machining possibilities and optionsavailable, however for a machine with a pricetag similar to that of our competitors, we areoffering more flexibility and power”.PACK STARTERMain operation• Tool holder for 5 turning tools• Tool holder for 3 turning tools• Offset tool block with 8 bores to accept holders for work in main(4x) and counter operations (8x)• 3 drill / milling attachments with ESx20 collet• Tool block with 2 bores to accept drill holders for deep drilling ;mounts on the left side of the counter spindleCounter operation• Tool holder for 3 turning tools• 2 tool holder for end working positions with ESx 20 colletADVANCED PACKMain operation• Tool holder for 5 turning tools• Tool holder for 3 turning tools• Offset tool block with 8 bores to accept holders for work in main(4x) and counter operations (8x)• 5 drill / milling attachments with ESx20 collet• Tool block with 2 bores to accept drill holders for deep drilling ;mounts on the left side of the counter spindleCounter operation• Tool holder for 3 turning tools• 2 tool holder for end working positions with ESx20 collets• 5 drill / milling attachments with ESx20 colletsMEDTECH PACKMain operation• Tool holder for 5 turning tools• Tool holder for 3 turning tools• Offset tool block with 8 bores to accept holders for work in main(4x) and counter operations (8x)• 3 drill / milling attachments with ESx20 collet• 1 thread whirling unit• Tool block with 2 bores to accept drill holders for deep drilling ;mounts on the left side of the counter spindleCounter operation• Tool holder for 3 turning tools• 2 tool holder for end working positions with ESx20 collets• 5 drill / milling attachments with ESx20 colletsMEDTECH PACK02 / 13 decomagazine 7