TS550 Semi-viSible (Semi-exPoSed) fixing wiTh meTal ... - Trespa.info

Overview of technical installationdetailsThe following table gives a general overview of some ofthe most significant technical installation details in thosecountries where this fixing system is commonly used. Fordetails of certification see: Overview of available certificates.In certain countries specific certification requirements mayapply. For countries in which a certificate for this fixingsystem is available, the following table presents a summaryof the certificate. For countries in which no certificate for thisfixing system may be available, the information given in thefollowing table only contains an advise as to the installationcommonly used by Trespa customers, as based on Trespa’sexperience. For all countries Trespa strongly advises that thecustomer, project owner and architect seek independent advicefrom a construction professional regarding the accordance tonational and/or local building regulations of fixing systems.The information below does not contain all requirementswith regard to the certificates. For design and installation, thecomplete certificate(s) must be considered. To consult thesecertificates, please visit www.trespa.info/meteon/certificatesPanel thicknessPanel thickness (mm)Country with certificate8, 10, 13 NLMaximum panel height / lengthMax. panel dimensions A (mm)Country with certificate3050 (height) NLAFor the various panel widths, please see: Maximum fixing distances (panel span) and edge clearance.Joint widthJoint width (mm)Minimum screw head diameter + 5 mmCountry with certificateNLMinimum dimensions sub-frameMinimum dimension timber battens (mm)Country/Region with certificate95 x 34 NLEdge clearanceBoth fixed points and sliding points must be positioned inside the halved joint with a minimum edge clearance of 10 mm.Recommended maximum fixing distancesMaximum fixingdistances B (mm)Panel thickness (mm)for Satin / RockPanel thickness (mm)for Gloss CCountry/Regionwith certificate8 10 13 10 13Horizontal fixing distances(panel span)Vertical fixing distances(in tongue)600 750 950 550 750 NL500 500 500 500 500 NLcode U3056 version 2.0 date 14-06-2011BThe maximum permitted fixing distances shown have been designed with a maximum (wind) load of 600 N/ m² and maximum deflection of L/200.CBased on the surface properties of Gloss panels, the fixing distances are reduced.4Please check www.trespa.info for the latest version of this document