A G C O C utting P arts - AGCO Parts

SICKLE ASSEMBLIES FOR GLEANER(Formerly Allis-Chalmers/Deutz-Allis)COMBINES: Flex Cutterbars — Series 3 Flexhead (13' - 20'), Series 3 Rigid Head (20' - 30') (1984)F2, K2, L2, M2, N5, N6, N7Bolt-On Riveted Replacement for Sickle Number of Type of OEM Section Section OEMPart No. Part No. OEM Part No. Length Sections Section Part No. Part No. Head No.800-511 71328410 13 ft. 51 XH TS PL 71135135 412-051 71315990801-512 71328411 15 ft. 59 XH TS PL 71135135 412-051 71315990801-513 71328412 16 ft. 63 XH TS PL 71135135 412-051 71315990801-514 800-514 71328414 20 ft. 79 XH TS PL 71135135 412-051 71315990801-515 71328416 24 ft. 95 XH TS PL 71135135 412-051 71315990801-530 71328408 27 ft. 107 R TS PL 71122784 422-003 71315990801-539 71328409 30 ft. 119 R TS PL 71122784 422-003 71315990Position the knife drive head segment, center segmentor segments (for sickle lengths above 13'6) and endsegment in the correct order.Install sections inproper position.Place top splice (marked top) withcountersink holes up.Install nuts with taper going down intotop splices. Tighten to 9 ft. - lbs.Position bottom splice(marked bottom) withcountersink holes down.Install splice bolts from bottom. Use allenwrench (enclosed) to hold splice bolts fromturning while installing nuts.COMBINES: Series 3 Headers, Model N after S/N 19301, Model F after S/N 70001, Model L, Mafter S/N 61001, All Model R (1985)Segmented AssembliesReplacement Head Head Center Center Tail Tail Splice SpliceFor One- Sickle Section Type of Segment Segment Segment Segment Segment Segment Kit KitPiece Knife Length Part No. Section Part No. Quantity Part No. Quantity Part No. Quantity Part No. Quantity71342524 24 ft. 71116939 R BT BM 803-188 1 803-174 2 803-177 1 711-012 371342527 27 ft. 71116939 R BT BM 803-188 1 803-174 3 803-176 1 711-012 471342530 30 ft. 71116939 R BT BM 803-188 1 803-174 3 803-177 1 711-012 4Note: Must be purchased in individual segments. Only available in specified sections as listed. Segments are UPS shippable.See page 1 for abbreviation explanations. See page 3 for packaging info. 15