Tender for setting up of Racking System in Drug ... - Nrhmharyana.org

No.Technical specifications of walk in cooler(A) Cold roomCold Room Size 10 ft x 10 ft x 10 ft (approx area 1000 cubic ft. +/-110 cubic ft.)2 80mmPUF panel wall single door for entering.Must have minimum of two 15 Amp and two 5 Amp Electrical3 points with good finish and temperature display Unit and datalogger with printer with showing interval of 15 min.4 DoorsOne door of size 900 mm x 2000 mm with PUF 80 mm along witha)view port of 1ft x 1ft in each door.b) Doors with Airtight Seal Gasket and locks.c) Safety release Knob.Wall panel: 80 mm thick PUF panel with 0.5mm TCT Prepainted5Galvanized Iron (PPGI) on outer side and inner side.Ceiling panel- 80 mm thick PUF panel with 0.5mm TCT PPGI on6outer side and inner side.7 Floor : insulated with marble / stone / anti skid flooring.8 Independent lights, switches for illumination.9 Refrigeration units: 2 (Two) units with each of 15000 BTU/Hr.10 Final Cold room temperature required: 2°C TO 8°C11 R22 Refrigerant/CFC free.12Suitable hermetically sealed Compressors Make: EmersonCopeland / Danfos / Bidzer13 Suitable Condensing units (2 Nos)-three phase, 50Hz, 220V-240V.14 Suitable evaporating units : 2 Nos.15 Electrical panel-MCB of suitable capacity.16 Automatic off cycle defrosting units.Stainless steel racks (Qty 12 nos) with 5 shelves of sizes1736"x18"x72"Electrical works including wiring and connections, plug points,18 civil works, masonry works, Breakage / constructions of wallportions / structural supports for wall.19 Fire Extinguisher, smoke detector, misc. control panels.20Service back up: The suppliers should ensure Service back upwithin 24 hours in case of any break down.21 Should have carried out similar kind of work with 5 or more26