Service A-320 1st Stage.pdf - Apollo Sports

More documents

Recommendations

Info

DISASSEMBLYUsing a curved o ring picker, carefullypick up the o ring and remove fromthe chamber and discard.After removing the o ring check theteflon back up ring for damage.Any signs of damage (scoring etc) iscause for rejection, in this case a newbalance chamber must be fitted.Remove and inspect the o ringfrom the groove on the HP moduleA -<strong>320</strong>
INSPECTION & CLEANINGCheck the HP seat knife edgeorifice (cone) for damage priorto re assembly.The pushrod assembly must beinspected for corrosion on the pin,also any bending of the pin.If any damage is noted replace the shaft.All threads are checked for damage, look for peelingchrome and damage caused by crossed threads.A -<strong>320</strong>
Page 1 and 2: Technical ManualA-320 Balanced 1st
Page 3 and 4: Haapalainen Aarne Johannes s. 6.1.1
Page 5 and 6: DISASSEMBLYRemove the DIN fittingfr
Page 7 and 8: DISASSEMBLYHold the 1 st stage in a
Page 9 and 10: DISASSEMBLYPlace a low pressure air
Page 11: DISASSEMBLYPlace the HP module on a
Page 15 and 16: INSPECTION & CLEANINGA quick check
Page 17 and 18: ASSEMBLYHp Module AssemblyApart fro
Page 19 and 20: ASSEMBLYSit the retaining ring on t
Page 21 and 22: ASSEMBLYLightly lubricate the o rin
Page 23 and 24: ASSEMBLYUse your nylon drift (or yo
Page 25 and 26: ASSEMBLYReplace the adjusting screw
Page 27 and 28: ASSEMBLYAttach the Apollo low press
Page 29 and 30: ASSEMBLYUse a 6mm Allen key wrench
Page 31: ASSEMBLYThe first stage DIN or Yolk

Service A-320 1st Stage.pdf - Apollo Sports

Create successful ePaper yourself

Delete template?

Save as template?