Service A-320 1st Stage.pdf - Apollo Sports

More documents

Recommendations

Info

ASSEMBLYCheck to ensure the retaining ringis located correctly in its groove.CAUTIONWhen inspecting the retaining ringfor security, be sure to wear eyeprotection and never point theassembly directly at your face.Lubricate and install the o ring tothe HP module groove.A -<strong>320</strong>
ASSEMBLYLightly lubricate the o ring on theHP module, lubricate the threadsvery lightly (if at all) and install themodule assembly.Using the 1 st stage driver TL00002, screwthe module into position.DO NOT tighten down hard. Tighten untilthe module bottoms and then back outapproximately 1/64 of a turn.This will prevent the module locking intoposition after use.A -<strong>320</strong>
Page 1 and 2: Technical ManualA-320 Balanced 1st
Page 3 and 4: Haapalainen Aarne Johannes s. 6.1.1
Page 5 and 6: DISASSEMBLYRemove the DIN fittingfr
Page 7 and 8: DISASSEMBLYHold the 1 st stage in a
Page 9 and 10: DISASSEMBLYPlace a low pressure air
Page 11 and 12: DISASSEMBLYPlace the HP module on a
Page 13 and 14: INSPECTION & CLEANINGCheck the HP s
Page 15 and 16: INSPECTION & CLEANINGA quick check
Page 17 and 18: ASSEMBLYHp Module AssemblyApart fro
Page 19: ASSEMBLYSit the retaining ring on t
Page 23 and 24: ASSEMBLYUse your nylon drift (or yo
Page 25 and 26: ASSEMBLYReplace the adjusting screw
Page 27 and 28: ASSEMBLYAttach the Apollo low press
Page 29 and 30: ASSEMBLYUse a 6mm Allen key wrench
Page 31: ASSEMBLYThe first stage DIN or Yolk

Service A-320 1st Stage.pdf - Apollo Sports

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?