TABLE OF CONTENTS - Hannspree

More documents

Recommendations

Info

User’s ManualMAKING CONNECTIONSCONNECTING TO A PCTurn off your computer before performing the procedure below.1. Connect one end of the VGA cable to the back of the monitor and connect the other end to thecomputer’s VGA port.2. Connect one end of the DVI cable (optional) to the back of the monitor and connect the other endto the computer’s DVI port.3. Connect the audio cable between the monitor's audio input and the PC's audio output (greenport).4. Plug one end of the AC power cord to the LCD monitor’s AC input socket, and the other end toWall outlet.5. Turn on your monitor and computer.Figure.2. Connecting to a PC1 Power AC Input 2 LINE IN (optional)3 DVI Input (optional) 4 VGA Input10
User’s ManualADJUSTING THE VIEWING ANGLE• For optimal viewing it is recommended to look at the full face of the monitor, then adjust themonitor’s angle to your own preference.• Hold the stand so you do not topple the monitor when you change the monitor’s angle.• You are able to adjust the monitor’s angle from -5° to 15°.NOTES:Figure.3. Monitor Angle• Do not touch the LCD screen when you change the angle. It may cause damage or break the LCDscreen.• Be careful not to place fingers or hands near the hinges when tilting the monitor, otherwisepinching can result.11
Page 4 and 5: User’s ManualTABLE OF CONTENTSSAF
Page 6 and 7: User’s ManualSPECIAL NOTES ON LCD
Page 8: User’s ManualINSTALLATION INSTRUC
Page 13 and 14: User’s ManualFRONT PANEL CONTROL
Page 15 and 16: User’s ManualHOW TO ADJUST A SETT
Page 17 and 18: User’s Manualthe OSD. Enter the o
Page 19 and 20: User’s ManualTECHNICAL SUPPORT (F
Page 21 and 22: User’s ManualERROR MESSAGE & POSS
Page 23 and 24: User’s ManualAPPENDIXSPECIFICATIO
Page 25 and 26: User’s ManualSPECIFICATIONSHL229D

TABLE OF CONTENTS - Hannspree

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?