ATC-1000 Operating Manual - Rev 1 - Peek Traffic

Chapter 2 — Quick Start: Getting a Unit Up and RunningRecording the MAC AddressThe MAC address is a globally unique identifier assigned to each Ethernet networkadapter card. The MAC address has been assigned and set at the Peek factory. Thecurrent address is displayed as the bottom line of text on the Revisions screen (MAINMENU > 1.STATUS > D.REVISIONS.)Important If the MAC address is not present (or set to all zeros ’00-00-00-00-00-00’), you will need to return the unit to Peek Traffic, sothat a valid MAC address can be installed.Write down the MAC address for the controller and associate it with the location and IPaddress you will be assigning to this unit.Setting the Cabinet AddressThe firmware of the ATC-1000 controller had its start in the Peek IQ ASTC CentralBusiness District controller, also known as the CBD controller. The CBD controller has avery specific requirement for a ‘cabinet address’. At power on, or controller reset, theCBD controller automatically reads the cabinet address. If the controller’s internalcabinet address does not match the address provided by the address circuit in thecabinet itself, the controller and the MMU will place the intersection into Flash.This check of the cabinet address is not a NEMA function, so it is not done as part of theATC-1000 controller’s startup. However, the cabinet address is used by the IQ Linksoftware to identify each controller to which it is communicating. The current value ofthe cabinet address stored in the ATC-1000 controller is displayed as the last fourcharacters on the second row of the standard Controller Timing Status screen. Thecabinet address can also be seen, and edited, on the IP/Cabinet Address setup screen(MAIN MENU > 2 > 1 > 5 > 3).1. Power on the controller.2. Navigate to the IP/Cabinet Address Setup screen. (MAIN MENU > 2 > 1 > 5 > 3)2.1.5.3 IP/CAB ADDR SETUPCabinet Address: 3CC6IP Address SYSTEM: 128.002.060.198IP Address LOCAL : 010.247.001.002Figure 28 – IP/Cabinet Address Setup screen44 ATC-1000 Advanced Traffic Controller