SUNNY BOY 3000TL / 4000TL / 5000TL - User Manual - Solar 360

SMASMA Solar Technology AGwww.SMA.dePV InverterSUNNY BOY 3000 TL / 4000 TL / 5000TLUser ManualSonnenallee 134266 Niestetal, GermanyTel.: +49 561 9522 4000Fax: +49 561 9522 4040E-Mail: Vertrieb@SMA.deFreecall: 0800 SUNNYBOYFreecall: 0800 78669269SB30 TL_40 TL_50TL-BEN084420 IME-TB-SBXTL-20 Version 2.0 ENDisplay OperationMeasurement AccuracyThe display shows the current values of your PV system. The values are updated every five seconds.You can operatethe display by tapping on the Sunny Boy's lower cover.Tap once:Tap again:The background illumination switches on for one The diagram displays the course of the lastminute.The diagram displays the course of the16 days.Tapping again switches the displaylast 16 feeding hours.to the next message.The Sunny Boy is not equipped with a calibrated meter.The display values may deviate from the actual values andmust not be used as a basis for invoicing.The Sunny Boy's measured values are required for the system managementand to control the current to be fed to the grid.GlossaryDiagramPower DisplayThe output of the Sunny Boy is shown as a diagram in the display.The dailygraph is displayed by default.The right bar of the diagram represents thecurrent hour. In case the Sunny Boy does not feed any power to the grid ( e. g.at night or in case the modules are covered with snow)a gap is inserted intothe chart.The column for the current hour is adjusted every five seconds.After fourseconds, it goes out for one second and then displays the current value.BluetoothBluetooth is a radio technology that allows Sunny Boy devices and communication devices to communicatewith each other. Bluetooth communication does not require visual contact between the devices.Electronic Solar SwitchThe Electronic Solar Switch is part of the Sunny Boy's DC isolator.The Electronic Solar Switch must besecurely inserted into the bottom of the Sunny Boy and may only be removed by a qualified electrician.EnergyEnergy is measured in Wh ( watt hours), kWh ( kilowatt hours) or MWh ( megawatt hours).The energy is thepower calculated over time. If, for example, your Sunny Boy operates at a constant output of 3000 W forhalf an hour and then at a constant output of 2000 W for another half hour, it has fed 2500 Wh of energyinto the gird within that hour.PowerPower is measured in W ( watts), kW ( kilowatts) or MW ( megawatts). Power is a momentary value.It displaysthe power your Sunny Boy is currently feeding into the grid.The power and energy of the Sunny Boy are displayed in the following three fields: Power, Day and Total.Thedisplay is updated every 5 seconds.PowerThe power that the Sunny Boy is feeding into the grid is displayed here.DayThe energy generated on this day is displayed here.This equals the energygenerated between the Sunny Boy's start up in the morning to the current timeTotalThe total energy that the Sunny Boy has generated throughout its service life isdisplayed here..Contact••••If you have technical problems concerning our products,contact your installer or the SMA Technical ServiceLine. We require the following information in order to provide you with the necessary assistance:Type of the Sunny BoySerial number of the Sunny Boy ( see name plate)Type and number of modules connectedEvent number or display of the Sunny BoyExplanation of the LEDsGreen LED blinking:Waiting for sufficient insolationGreen LED on:OperationRed LED on: Disturbance: contact the installer and specify the event and the serial number.Blue LED on:Sunny Boy is connected to a Bluetooth network and can communicate with otherdevices that have the same network ID.SMA Solar Technology AGTel.: +49 (561) 95 22 - 499Fax: +49 (561) 95 22 - 4699serviceline@ SMA.dewww. SMA.deInstaller contact

SUNNY BOY 3000 TL / 4000 TL / 5000TLSerial Number•••DANGER!Lethal voltages inside the Sunny Boy!Do not open the Sunny Boy.Do not remove the cable from the Sunny Boy.Work on the Sunny Boy must only be carried out by a qualifiedelectrician.Identification of the Sunny Boy bythe name plateCAUTION!Danger of burn injuries due to hot housing parts!Some parts of the Sunny Boy housing can become hot duringoperation. However,this does not apply to the lower housingcover.• Only touch the lower housing cover during operation.Lower housing coverGraphic displayLEDsYield loss due to poor heat dissipation!• Do not place objects on the housing.Electronic Solar SwitchGraphic displayThe display is operated by tapping on the lower Sunny Boy coverGraphic display of the Sunny Boy's outputdisturbanceContact installer,and specify event and serial numbersCurrent outputDaily energyTotal energy generated since the Sunny Boywas installedText line for displaying an eventSystem OverviewBluetooth connection to other invertersPV current/voltageSwitch open:No feedingSwitch closed:feedingGrid voltage/currentSwitches between the inputsA and B every 10 seconds( Only for Sunny Boy 4000 TL / 5000 TL)ABPV generator event numberGrid event numberSunny Boy event numberCleaning and MaintenancePower reduction due to excessive temperature• Clean fan ( see below)• Provide better ventilation for Sunny BoyVisual inspectionRegularly inspect the Sunny Boy and the cable for visible damage and dirt. In case of damage,contact your installer.Clean fan ( Only Sunny Boy 4000 TL / 5000 TL)You can clean the fan housing from the outside using a vacuum cleaner.If there is a considerableamount of dirt, contact your installer.Dirty housing and displayClean the housing and the display using a damp cloth. Do not use solvents,abrasives or corrosiveliquids.Fanswww. SMA.de