PROFDRIVE 10-2WD / 12-2WD - Farmi Forest

PROFDRIVE 10-2WD / 12-2WDASSEMBLYSAFETY!WARNING!Read the assemblyinstructions before installingthe trailer. Careless assemblyand non-compliance withinstructions may causehazards to users anddamages to the machine.The warranty is void for machines orcomponents which have been damaged dueto non-compliance with approved assemblyand installation instructions.Before beginning the assembly work, ensurethat there is no pressure in the hydraulicsystem and that the trailer cannot be turnedon accidentally.Never connect or disconnect pressure hosesor components when the hydraulic systemis pressurized.Distance A, when the distance between the splinedshafts is at its shortest.3.40AAFirst cut the thicker shaft shield to the correctlength (1). Remember to leave at least a 40mm clearance. Then cut a similar length offthe PTO shaft in the same way. File off theburr.ASSEMBLY1.2.3.4.5.Attach the trailer to the tractor’s tow bar.Adjust the length of the PTO shaft in allpositions.Install the control panel in the cabin so thatusers have optimal access to the switch andadjusting wheel.Connect the trailer brakes’ hydraulics to thetractor’s hydraulic system. See the illustrationfor brake hydraulics.Connect the shaft control to the tractor’shydraulic system.SHORTENING THE PTO SHAFT1 2Shortening the PTO shaft4.Interconnect the tubes and check that theshaft has been shortened enough by movingthe machine gently. Ensure that there is a 40mm clearance. Also move the machinesideways to check that the shaft moves freely.1.2.Connect the device to the tractor.Measure the distance between the splinedshafts (Distance A)12