1981-87 CHEV PICK-UP - Vintage Air

GLOVE BOX MODIFICATIONUSE GLOVE BOX MODIFICATION TEMPLATE PROVIDED ON PAGE 26.PLACE TEMPLATE ON THE OUTSIDE OF THE GLOVE BOX. MARK THE OUTSIDE OF THE GLOVE BOX ALONGTHE FRONT OF THE TEMPLATE AS SHOWN IN FIGURE 17 BELOW.PLACE THE SAME TEMPLATE ON THE OUTSIDE OF THE GLOVE BOX ON THE OPPOSITE SIDE. MARK THE OUTSIDEOF THE GLOVE BOX ALONG THE FRONT OF THE TEMPLATE AS SHOWN BELOW.MARK THE BOTTOM OF THE BOX CONNECTING EACH END OF TEMPLATE.CUT THE BOX ON THE LINES YOU HAVE MARKED. DISCARD THE FRONT PORTION OF THE BOX.INSTALL THE NEW SUPPLIED GLOVE BOX BY PRESSING THE S-CLIPS ONTO THE OEM PORTION OF THE BOX.AS SHOWN IN FIGURE 17a BELOW.OEM wo ACGLOVE BOXDISCARD FRONTPORTION OFBOXDISCARD FRONTPORTION OFBOXOEM wo ACGLOVE BOXFACTORY AIRGLOVE BOXTEMPLATEFACTORY AIRGLOVE BOXTEMPLATECUT BOX WITH AHACK SAW BLADEON THESE THREEFRONT LINES ONLYFIGURE 17CUT BOX WITH AHACK SAW BLADEON THESE THREEFRONT LINES ONLYMODIFIED GLOVEBOXFIGURE 17a901182 REV A 6/13/11, INST 81-87 CHEV P-UP wo AC EVAP KIT PG 18 OF 2718